Page 2 - E page; APPROVED FOR RESIDENTIAL APPLIANCES
2 PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING. INSTALLATION MUST COMPLY WITH ALL LOCAL CODES. IMPORTANT: Save these Instructions for the Local Electrical Inspector’s use. INSTALLER: Please leave these Instructions with this unit for the owner. OWNER: Please retain these instructions for future...
Page 3 - able of Content
3 www.zephyronline.com T able of Content s Important safety Notice ..................................................................... 4 Electrical & Installation requirements ............................................. 5 Electrical requirements .................................................
Page 4 - READ AND SAVE THESE INSTRUCTIONS
4 Import ant safety Notice CAUTION: FOR GENERAL VENTILATING USE ONLY. DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS ORVAPORS. WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:A. Use this unit only in the manner intended by the manufacturer. If ...
Page 5 - allation requirement
5 www.zephyronline.com Electrical & Inst allation requirement s ELECTRICAL REQUIREMENTS Important: Observe all governing codes and ordinances. It is the customer’s responsibility:• To contact a qualified electrical installer. • To assure that the electrical installation is adequate and in confor...
Page 6 - List of Materials
6 List of Materials PARTS SUPPLIED: • Blower unit housing • Hood canopy • Metal filter x 1 • Halogen light bulb x 2 • Hardware Packet:TransitionAllen spanner x 1Lower bracket x 2Upper Bracket x 2Use, Care and Installation guideTemplateCloth2,9x9,5 screws x 2 (to fix the transition)4,5x16 screws x 4 ...
Page 7 - Dimensions and clearances
7 www.zephyronline.com 21" 9" 1/16 9" 13/16 15/16" - 1" 3/4 30"-36" 2" 3/4 9" 13/16 Dimensions and clearances Cut out for ventingsystem andconduit 1" 1/4 1" 1/4 9" 1/4 23" 5/16 10" 21" 3/4 7" 1/16 3" 3/8 13/16" 13/16" Cut ou...
Page 11 - Inst
1 1 www.zephyronline.com 8. Fit the blower unit housing inside the cabinetthrough the bottom opening.Check that fixing springs goes over the bottompanel.. Bottom opening Bottom panel Fixing springs 9. Apply two brackets (one per side) to the blower unit housing......... Upper bracket ....... lock in...
Page 14 - Description of the hood
1 4 Description of the hood 1 Control panel 2 Grease filter 3 Grease filter release handle 4 Halogen lamp (position and nr. of lamps may vary) 5 Sliding Glass 6 Hood canopy 6 1 2 3 4 5
Page 15 - Controls; B C D
1 5 www.zephyronline.com Controls Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suctionis switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutesapproximately after terminating cookin...
Page 16 - Maintenance
1 6 Maintenance CLEANING The cooker hood should be cleaned regularly internally and externally.For cleaning use the supplied cloth moistened with a neutral liquid detergents. Avoid abrasive detergents. Warning: Failure to carry out the basic standards of the cleaning of the cooker hood and replaceme...
Page 17 - rouble Shooting
1 7 www.zephyronline.com T rouble Shooting After installation, theunit doesn’t work? Light works, but motor isnot turning. The unit is vibrating. The motor is working,but the lights are not. The hood is not ventingout properly. Metal filter is vibrating. 1. The power source is not turned ON. 2. The ...
Page 18 - arranty
1 8 W arranty TO OBTAIN SERVICE UNDER WARRANTY: or any Service Related Questions, please call: 1-888-880-8368 Staple your receipt here. Proof of the original purchase date is needed to obtain service under the warranty. TO OBTAIN SERVICE UNDER WARRANTY: You must present proof of original purchase da...
Page 19 - Part Description
1 9 www.zephyronline.com List of Part and Accessories Part Description Part# halogen bulb, 12V 20 W metal filter Part Description Part# Ductless Recirculating Kit charcoal replacement filter Z0B-0013 ZRC-00GL Z0F-C063 remote control GF02ZA