Page 3 - SAFETY FIRST; s y m b o l c o n c e r n; NOTE; CONTENTS; Troubleshooting guide ...........................19
SAFETY FIRST Instructions contained in warnings within thism a n u a l m a r k e d w i t h a s y m b o l c o n c e r n c r i t i c a l p o i n t s w h i c h m u s t b e t a k e n i n t oc o n s i d e r a t i o n t o p r e v e n t p o s s i b l e s e r i o u sb o d i l y i n j u r y , a n d f o r t h...
Page 4 - Symbols carved on the machine
❲ 4 ❳ For safe operation and maintenance, symbols arecarved in relief on the machine. According to theseindications, please be careful not to take a mistake. (a) The port to refuel the "MIX GASOLINE" Position: FUEL TANK CAP (b) The direction to close the chokePosition: AIR CLEANER COVER (c) ...
Page 5 - For safe operation; • Before operating the machine, be sure to
2. For safe operation • Before operating the machine, be sure to read through this manual carefully andfollow proper operating instructions. • Never allow children or anyone unable to fully understand the instructions given inthe manual to use the machine. ■ NOTES FOR OPERATION • Before using the ma...
Page 6 - NOTES FOR MAINTENANCE
❲ 6 ❳ • Do not touch the spark plug or the plug wire while the engine is in operation. They may causean electric shock. • Do not touch metallic parts such as the muffler, s p a r k p l u g , e t c . w i t h b a r e h a n d s d u r i n g t h eoperation of engine or immediately after a stop.They may b...
Page 9 - WARNING
• Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel.Make sure to stop the engine and allow itcool before refueling the unit. Select outdoorbare ground for fueling and move at least3m(10ft) away from the fueling point beforestarting the engine. • T h e R e d M a x e ...
Page 10 - FUELING THE UNIT
❲ 10 ❳ other containers. 6. Indicate the contents on outside of container for easy identification. ■ FUELING THE UNIT 1. Untwist and remove the fuel cap. Rest the cap on a dustless place. 2. Put fuel into the fuel tank to 80% of the full capacity. 3. Fasten the fuel cap securely and wipe up any fuel...
Page 12 - IMPORTANT
❲ 12 ❳ • F u e l ( G a s o l i n e ) i s h i g h l y f l a m m a b l e a n d incorrect handling will cause fire accident.Strictly avoid smoking or fire during mixingor supplying the fuel. • Be sure to stop the engine and allow it to be cooled before refueling. • Spilled fuel shall be completely wipe...
Page 13 - STARTING ENGINE; P u s h a p r i m i n g p u m p a t l o w e r s i d e o f t h e
7. Operation ■ STARTING ENGINE 1. P u s h a p r i m i n g p u m p a t l o w e r s i d e o f t h e carburetor several times until you can see thefuel flows into a clear tube. (F3) 2. Put the choke lever to CLOSE position, and set t h e t h r o t t l e l e v e r 1 / 3 t o 1 / 2 o p e n f r o m f u l l...
Page 14 - STOPPING ENGINE; Return the throttle lever and run engine 1 to 2; AFTER USE; Release a drain plug at lower part of the pump
■ STOPPING ENGINE In case of emergency, immediately stop theengine. 1. Return the throttle lever and run engine 1 to 2 minutes for cooling down. 2. Press the engine stop button(yellow) until the engine completely stops. (F5) ■ AFTER USE 1. Release a drain plug at lower part of the pump and drain the...
Page 15 - AIR CLEANER; • Clogged fuel filter and choked vent valve reduce
❲ 15 ❳ 8. Maintenance • Be sure to stop the engine and keep off fire for inspection and maintenance. • A l w a y s u s e o u r g e n u i n e p a r t s / o i l s o r o u r specified goods for replacement. ■ AIR CLEANER After every 25 hours of operation, release the airc l e a n e r c o v e r a n d r ...
Page 16 - • Operation with no fuel filter cause clogging of the; SPARK PLUG
❲ 16 ❳ • Operation with no fuel filter cause clogging of the carburetor. Fuel Filter Part No. 3302-85400 ■ SPARK PLUG Do not touch the spark plug with bare handsimmediately after stopping the engine. There isa possibility of burns by high temperature. After every 25 hours of operation, remove thes p...
Page 17 - ADJUSTING IDLE SPEED
■ ADJUSTING IDLE SPEED Engine idle speed is already adjusted at shipping.However, if the engine stalls due to too low enginespeed when fully returning the throttle lever or ifyou feel it to be too high, adjust the speed. Idlea d j u s t i n g s c r e w i s o n t h e u p p e r p a r t o f t h ecarbur...
Page 18 - STORING FOR LONG PERIOD; • To stop using your machine for a long
❲ 18 ❳ 9. Storage ■ STORING FOR LONG PERIOD • To stop using your machine for a long period, drain fuel from the fuel tank andthe carburetor before storing it. Fuel leftbehind inside there for long period mayc l o g t h e c a r b u r e t o r a n d c a u s e e n g i n et r o u b l e s a s n o s t a r ...
Page 19 - Troubleshooting guide
10. Troubleshooting guide COUNTERMEASURE Change with proper fuel(see Page 9) Open choke and repeat pulling rope (see Page 13) cleaning Cleaning of electrode or replace plug (see Page 16) Top up with water(see Page 11) Tighten securely not to suck air Replace with proper one(ask for service) Replace ...
Page 20 - Warranty certificate
Warranty certificate Komatsu Zenoah Co. The Komatsu Zenoah product model No.PE2500H is covered by a Warranty of 6 months fromthe following date of purchase. In the case of professional machine used for professional work,such machines are covered by a Warranty of 3 months. We undertake according to o...