Zenoah G2000 - Manuals - manualsarea.com

Page 2 - EXPLANATION OF SYMBOLS AND SAFETY WARNINGS; RISK OF DAMAGING HEARING

G2000 GB-2 EXPLANATION OF SYMBOLS AND SAFETY WARNINGS APPROVAL NUMBER OF CE EXHAUST EMISSION REGULATION (2002/88/EC) e13*97/68SH1G3*2002/88*0299*00 Read operator's instructionbook before operating thismachine. Wear head, eye and earprotection. Use the chain sawwith two hands. Warning! Danger ofkickb...

Page 3 - Contents

G2000 GB-3 G B Contents 1. For Safe Operation ................................................................... 4 2. Explanation of Symbols on the Machine .................................. 8 3. Installing Guide Bar and Saw Chain ......................................... 9 4. Fuel and Chain Oil .....

Page 4 - For safe operation

G2000 GB-4 1. For safe operation WARNING This chainsaw has been especially designed for treemaintenance and should therefore only be used bytrained operators when working on trees. 1. Never operate a chain saw when you are fatigued, ill, or upset, or under theinfluence of medication that maymake you...

Page 8 - Explanation of Symbols on the Machine

G2000 GB-8 2. Explanation of Symbols on the Machine The port to refuel “MIX GASOLINE” Position: Fuel cap The port to top up chain oil Position: Oil cap Setting the switch to the “O” position, the engine stops immediately. Position: Front at the top of the rear handle Starting the engine. If you turn...

Page 9 - Installing Guide Bar and Saw Chain

G2000 GB-9 G B Open the box and install the guide bar and the sawchain on the power unit as follows: The saw chain has very sharp edges. Use thick pro-tective gloves for safety. 1. Pull the guard towards the front handle to check that the chain brake is not engaged. 2. Loosen the nuts and remove the...

Page 10 - Fuel and Chain Oil

G2000 GB-10 4. Pour in the rest of gasoline and agitate again for at least one minute. As some oils may be difficult to agitate de-pending on oil ingredients, sufficient agitation is nec-essary for the engine to last long. Be careful that, if theagitation is insufficient, there is an increased dange...

Page 11 - Operating the Engine

G2000 GB-11 G B 6. When engine has ignited, first push in the choke knob to the first-stage position and then pull the starteragain to start the engine. 7. Allow the engine to warm up with the throttle lever pulled slightly. Keep clear of the saw chain as it will start rotatingupon starting of engin...

Page 15 - Maintenance of Saw Chain and Guide Bar

G2000 GB-15 G B ■ SAW CHAIN It is very important for smooth and safe operation toalways keep the cutters sharp. The cutters need to be sharpened when:• Sawdust becomes powder-like.• You need extra force to saw in.• The cut path does not go straight.• Vibration increases.• Fuel consumption increases....

Page 16 - Troubleshooting Guide

G2000 GB-16 9. Troubleshooting Guide Case 1. Starting failure Make sure the icing prevention system is not working. Check fuel for wateror substandard mix-ture. Replace with properfuel. C h e c k f o r e n g i n eflooding. Check spark ignition. Remove and dry thespark plug.Then pull the starteragain...

Page 17 - Limited warranty

G2000 GB-17 G B 11. Specifications Power unit: Displacement (cm 3 ): ............................................. 18.3 Fuel: ................ Mixture (Gasoline 50 : Two-cycle oil 1) (when using ZENOAH genuine oil)Fuel tank capacity (cm 3 ): ....................................... 170 Chain oil: ......