Whirlpool WFC3C26XAUS - Manuals

EN 7 PROGRAMS TABLE Not all options can be used simultaneously.**) The duration of the program shown on the display or in the booklet is an estimate calculated on standard conditions. The actual time may varydepending on many factors such as temperature and pressure of the incoming water, room tempe...

8 OPTIONS AND FUNCTIONS OPTIONS can be selected directly by pressing the corresponding button (see CONTROL PANEL) . If an option is not compatible with the selected program see PROGRAMS TABLE , the corresponding LED flashes rapidly 3 times and beeps will sound. The option will not be enabled. DELAY ...

EN 9 DAILY USE 1. CHECK WATER CONNECTION Check that the dishwasher is connected to the water supply and that the top is open. 2. SWITCH ON THE DISHWASHER Press the ON/OFF button. 3. LOAD THE RACKS (see LOADING THE RACKS). 4. FILLING THE DETERGENT DISPENSER (see PROGRAMS TABLE). 5. CHOOSE THE PROGRAM...

10 LOADING THE RACKS UPPER RACK Load delicate and light dishes: glasses, cups, saucers, low salad bowls. (loading example for the upper rack) ADJUSTING THE HEIGHT OF THE UPPER RACK The height of the upper rack can be adjusted: high position to place bulky crockery in the lower basket and low positio...

EN 11 CLEANING THE SPRAY ARMS On occasions, food residue may become encrusted onto the spray arms and block the holes used to spray the water. It is therefore recom- mended that you check the arms from time to time and clean them with a small non-metallic brush. To remove the upper spray arm, turn t...

12 Your dishwasher may not work properly. Before contacting the Service Centre check if the problem can be solved by going through the following list. TROUBLESHOOTING PROBLEMS POSSIBLE CAUSES SOLUTIONS The dishwasher won’t start or does not respond to commands. The appliance has not been plugged in ...

EN 13 ATTENTION: If the appliance must be moved at any time, keep it in an upright position; if absolutely necessary, it may be tilted onto its back. CONNECTING THE WATER SUPPLY Adaptation of the water supply for installation should only be perfor- med by a qualified technician. The water inlet and ...

14 CONTACTING AFTER-SALES SERVICE When you contact the After-Sales Service, you must provide the codes shown on the rating plate attached to the left or right side inside the door of the dishwasher. The phone number is listed in the warranty booklet or on the website: www.whirlpool.com.au IEC 436 : ...

15 EN mm 590 590 598 850 850 448 min: 400 mm max: 800 mm ~1500 mm ~1500 mm ~2000 mm min: 25mm min: 0,05 MPa/0,5 Bar max: 1 Mpa/10 Bar min. 10 mm a b c 2x 3,5x16 mm SERVICE a 1 2 3 INSTALLATION GUIDE