Whirlpool W10258095A - Manuals

5 Install Anti-Tip Bracket 1. Remove the anti-tip bracket that is taped in the storage drawer. 2. Determine which mounting method to use: floor or wall. If you have a stone or masonry floor you can use the wall mounting method. 3. Determine and mark the edge of the range in the cutout space. The mou...

6 Electrical Connection 1. Disconnect power. 2. Use Phillips screwdriver to remove the terminal block cover screw located on the back of the range. 3. Remove plastic tag holding three #10-32 hex nuts from the middle post of the terminal block. 4. Add strain relief. Style 1: Power supply cord strain ...

9 Direct Wire Installation: Copper or Aluminum Wire This range may be connected directly to the fuse disconnect or circuit breaker box. Depending on your electrical supply, make the required 3-wire or 4-wire connection. 1. Strip outer covering back 3" (7.6 cm) to expose wires. Strip the insulati...

10 6. Use ³⁄₈ " nut driver to connect the neutral (white) wire to the center terminal block post with one of the #10-32 hex nuts. 7. Connect line 1 (black) and line 2 (red) wires to the outer terminal block posts with #10-32 hex nuts. 8. Securely tighten hex nuts. 9. Replace terminal block acces...

11 Verify Anti-Tip Bracket Location 1. On models with a storage drawer, pull drawer open to first stop position. Lift front of drawer to clear white wheels in drawer guides. Remove drawer and set it aside on a covered surface. On models with a warming drawer, the rear leg cannot be seen by removing ...

Moving the Range When moving range, slide range onto cardboard or hardboard to avoid damaging the floor covering. If removing the range is necessary for cleaning or maintenance: For power supply cord-connected ranges: 1. Slide range forward. 2. Unplug the power supply cord. 3. Complete cleaning or m...