Weider WESY92190 - Manuals

Weider WESY92190 – Manual in PDF format online.

Manuals:

Manual

Manual Weider WESY92190

Summary

Page 2 - Table of Contents

Important Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3Before You Begin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

Page 3 - Important Precautions

3 WARNING: Before beginning this or any exercise program, consult your physician. This is especiallyimportant for persons over the age of 35 or persons with pre-existing health problems. Read allinstructions before using. ICON assumes no responsibility for personal injury or property damagesustained...

Page 4 - Before You Begin

4 ASSEMBLED DIMENSIONS: Height: 77 in.Width: 38 in. Length: 61 in. Low PulleyStation WarningDecal 2 Foot Plate Row Bar Console High PulleyStation Ab PulleyStation Leg Lever Butterfly Arm Press Arm Shroud Warning Decal 2 Warning Decal 2 (on both sides of the weight mechanism inside of the shroud) War...

Page 5 - Assembly

5 Note: This introduction will save you moretime than it takes to read it! Identifying Parts To help you identify the small parts used in assem-bly, we have included a PART IDENTIFICATIONCHART located in the center of this manual. Placethe chart on the floor and use it to quickly identify dif-ferent...

Page 6 - Frame Assembly

6 1. Before beginning assembly, make sure you haveread and understood the information on page 5. Open the parts bag labeled ÒFRAME ASSEMBLY.Ó Press a 2Ó Square Outer Cap (51) onto each end ofthe Stabilizer (5). Insert two 5/16Ó x 2 3/4Ó Carriage Bolts (14) upthrough the Stabilizer (5) and place it f...

Page 8 - Arm Assembly

8 10. Press a 1 1/2Ó Square Inner Cap (33) into the end of the Seat Frame (36). Insert two 5/16Ó x 2 3/4Ó Bolts (67) through theSupport Plate (27) and the indicated holes in theFront Upright (42). Place the mounting bracket on theSeat Frame (36) over the two Bolts. Tighten a 5/16ÓNylon Locknut (53) ...

Page 10 - Cable Assembly

Cable Assembly 15. Open the parts bag labeled ÒCABLE ASSEMBLYAND PULLEYS.Ó For Cable identification and rout-ing during steps 15Ð30, refer to the CableDiagram and Cable ID Chart on page 19. Identify the High Cable (2). It is approximately 1631/2Ó long. It is the shortest cable and it has a ball onea...

Page 14 - Seat Assembly

31. Open the parts bag labeled ÒSEAT ASSEMBLY.Ó Attach the Backrest (41) to the Front Upright (42) withtwo 1/4Ó x 2 1/2Ó Screws (43) and two 1/4Ó FlatWashers (90). Seat Assembly 41 43 43 90 42 30. Wrap the Low Cable (9) around a 3 1/2Ó Pulley (35) in the direction shown. Attach the Pulley to the Fro...

Page 19 - Cable Diagram

19 Cable Diagram The Cable Diagram below shows the proper routing of the High Cable (2) and the Low Cable (9). The numbersshow the correct route for each Cable. Make sure that the Cables are routed correctly, that the Pulleys move smoothly, and that the Cable Traps do not touch or bind the Cables. I...

Page 20 - How to Use the Weight System

20 How to Use the Weight System PLUGGING IN THE POWER CORD Plug in the power cord to a 120-volt outlet. Keep thepower cord away from walkways and heated surfaces.Turn on the power when using the weight system, orthe weight system could be damaged. When you arefinished using the weight system, always...

Page 22 - Trouble-shooting and Maintenance

22 31 63 66 35 Additional slack can be removed by using the PulleyPlates (31). The Pulley Plates have several sets of adjust-ment holes. By moving one or both pulleys to a differentset of holes, the cables will be tightened. To move a Pulley, remove the 3/8Ó Nylon Jamnut (63) andthe 3/8Ó x 1 1/2Ó Bo...

Page 24 - Part Identification ChartÑWESY92190

5/16" Nylon Jamnut (91) 3/8" Flat Washer (55) 5/16" Flat Washer (56) 3/8" Nylon Locknut (57) 3/8" Nylon Jamnut (63) 3/8" Plain Nut (85) 1/4" x 2" Bolt (71) 1/4" x 2 1/2" Screw (43) 1/4" x 2" Carriage Bolt (38) 5/16" x 1 3/4" Bolt (58) 5/16"...

Page 26 - Part ListÑModel No. WESY92190

Note: Ò#Ó indicates a non-illustrated part. Specifications are subject to change without notice. Part ListÑModel No. WESY92190 R1299A Key No. Qty. Description Key No. Qty. Description 1 1 Top Frame 2 1 High Cable 3 2 1Ó Round Cover Cap 4 4 1Ó Retainer 5 1 Stabilizer 6 4 ÒVÓ-Pulley 7 2 Plastic Bushin...

Page 27 - Exploded DrawingÑModel No. WESY92190

34 34 30 30 44 33 28 30 34 28 30 34 22 71 38 17 37 13 91 33 29 36 74 73 75 45 45 21 21 3 4 4 3 15 6 57 15 48 47 9 11 58 56 53 53 18 5 51 51 14 52 8 53 1 21 21 67 56 65 50 6 63 35 55 54 2 90 43 41 42 24 10 17 72 67 27 66 35 55 66 66 35 35 55 53 69 50 6 55 21 40 53 21 21 49 77 77 49 46 46 68 43 93 55 ...

Page 28 - Ordering Replacement Parts; Limited Warranty

Ordering Replacement Parts To order replacement parts, simply call our Customer Service Department toll-free at 1-800-999-3756, Mondaythrough Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays). To help us assist you, please be pre-pared to give the following information: 1. The MODEL NUM...