Vulcan SPER2 ML-52919 - Manuals

Page 2 - UNPACKING

— 2 — Installation, Operation and Care of MODEL SPER1 & SPER2 ELECTRIC FRYERS PLEASE KEEP THIS MANUAL FOR FUTURE REFERENCE GENERAL Your Vulcan fryer is produced with quality workmanship and material. Proper installation, usage andmaintenance of your fryer will result in many years of satisfactor...

Page 3 - INSTALLATION CODES AND STANDARDS; Your Vulcan fryer must be installed in accordance with:; LEVELING; A wiring diagram is located inside the front door panel.

— 3 — INSTALLATION CODES AND STANDARDS Your Vulcan fryer must be installed in accordance with: 1. State and local codes. 2. The National Electrical Code, ANSI/NFPA No. 70 (latest edition). Copies may be obtained from The National Fire Protection Association, Batterymarch Park, Quincy, MA 02269. 3. N...

Page 4 - OPERATION; BEFORE FIRST USE

— 4 — PL-40545-1 Power On Light High Limit Lights Temperature Controller Power Switch Trouble Light Fry / Melt Switch Heating Light OPERATION WARNING: HOT OIL AND PARTS CAN CAUSE BURNS. USE CARE WHEN OPERATING,CLEANING AND SERVICING THE FRYER. BEFORE FIRST USE Cleaning Clean the fryer thoroughly, fo...

Page 6 - Split Vat; Place crumb screens on top of shortening in tank.; Single Vat; Place crumb screen on top of shortening.; Melt Cycle; is functioning properly.; DRAINING AND FILTERING SHORTENING; Turn power switch OFF when draining or filling.

— 6 — Split Vat 1. Remove crumb screens. 2. Divide a 50-pound block of shortening into two equal halves (approximately 25 pounds each). 3. Place each half of the shortening directly on the heating elements in each well of the fry tank and slide back. 4. Place crumb screens on top of shortening in ta...

Page 7 - Allow shortening to cool before draining or filling.

— 7 — PL-40547-1 Drain Valves Drain Nipple 1. Allow shortening to cool before draining or filling. 2. Consult the operating instructions supplied by the manufacturer of your filtering system before filtering the shortening. 3. Firmly screw the fryer drain nipple (supplied) into the fryer drain valve...

Page 9 - Heating elements will heat up in excess of 600; Fry Tank; Set temperature control knob to 212

— 9 — PL-40546-1 Reset Button 7. Turn power switch OFF at termination of burn-off cycle. 8. Heating elements will heat up in excess of 600 ° F glowing red. If any do not glow, call a Vulcan- authorized service agency. Some smoking, crackling sound and puffs of flame will occur. This isnormal. If exc...

Page 10 - STAINLESS STEEL

— 10 — 6. Drain solution and discard. Close drain valve and fill tank half full with water. 7. Scrub entire inside of tank with a stiff bristle nylon brush. 8. Drain solution and rinse tank thoroughly with clean water. 9. Close drain valve and refill tank with clean hot (minimum 140 ° F) water. Add ...

Page 11 - MAINTENANCE; CALIBRATION PROCEDURES; to frying temperature.; LUBRICATION

— 11 — MAINTENANCE WARNING: HOT OIL AND PARTS CAN CAUSE BURNS. USE CARE WHEN OPERATING,CLEANING AND SERVICING THE FRYER. WARNING: DISCONNECT ELECTRICAL POWER SUPPLY BEFORE PERFORMING ANYMAINTENANCE. CALIBRATION PROCEDURES 1. Monitor shortening temperature 1" below the surface with an accurate te...