Page 2 - Battery installation; THIS SIDE UP; Telephone base and charger installation; If you do not hear a dial tone:
2 Battery installation Install the battery as shown below. Slide the battery compartment cover towards the center of the handset until it clicks into place. 3. Place the handset in the telephone base or charger to charge. 4. CHARGE light remains on when charging. Plug the battery connector securely ...
Page 3 - Battery charging; Tabletop to wall mount installation
3 Battery charging Once you have installed the battery, the screen indicates the battery status (see the table below). For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after 2 hours of continuous charging. If you place the handset ...
Page 4 - Telephone base overview; IN USE; Handset overview
4 Telephone base overview IN USE light Flashes when there is an incoming call, or another telephone sharing the same line is in use.On when the handset is in use. FIND HANDSET Press to page all system handsets. 1 and 2 lights On when the telephone base is paired and connected with a Bluetooth device...
Page 5 - Bluetooth; Pair and connect your first Bluetooth cell phone; Using the handset menu
5 Bluetooth To use a Bluetooth enabled cell phone with your DS6511 , you must first pair and connect your Bluetooth cell phone(s) with the telephone base. All DS6511 handsets can be used to make or answer calls on the cell line. Bluetooth wireless technology operates within a short range (a maximum ...
Page 6 - Telephone operation
6 The following are some of the telephone features you may wish to set. Refer to Telephone settings in the online Complete user’s manual for detailed instructions on setting all telephone features. Ringer volume You can adjust the ringer volume level, or turn the ringer off. Press MENU when the hand...
Page 7 - Place the handset in the telephone base or charger.
7 Call waiting When you subscribe to call waiting service from your telephone service provider, you hear an alert tone if there is an incoming call while you are on another call. For a home call, press FLASH to put the current call on hold and take the new call, or switch back and forth between call...
Page 8 - Answer an incoming call during an intercom call; Directory
8 Answer an incoming call during an intercom call If you receive an incoming call during an intercom call, there is an alert tone. To answer a home call, press /HOME . The intercom call ends automatically. To end the intercom call without answering the outside call, press OFF . The intercom call end...
Page 9 - Caller ID; Caller ID log; Add and register a handset
9 Caller ID This product supports caller ID services provided by most telephone service providers. Depending on your service subscription, you may see the caller’s name, number, date and time of calls that are sent by your telephone service provider after the first or second ring. Caller ID log The ...
Page 10 - NEW
0 Rewiring of telephone line for cable/VoIP service users If you have changed to cable/VoIP service through a modem/router/terminal adapter to establish telephone connection, the existing telephone jacks in your home may no longer work. Your cable/VoIP service provider uses a separate cable connecti...
Page 11 - know how to change it back to English.; Important safety instructions; SAVE THESE INSTRUCTIONS
Make sure the telephone line cord is plugged firmly into the telephone base and the wall jack. Unplug the electrical power to the telephone base. Wait for approximately 5 seconds, then plug it back in. Allow up to one minute for the cordless handset and telephone base to synchronize. Charge the batt...
Page 13 - Limited warranty; Please retain your original sales receipt as proof of purchase.; FCC, ACTA and IC regulations
3 Limited warranty What does this limited warranty cover? The manufacturer of this VTech Product warrants to the holder of a valid proof of purchase (“Consumer” or “you”) that the Product and all accessories provided in the sales package (“Product”) are free from defects in material and workmanship,...
Page 14 - FCC Part 68 and ACTA; Technical specifications
4 The Bluetooth ® word mark and logos are owned by Bluetooth SIG, Inc. and any use of such marks by VTech Holdings Limited is under license. VTech Holdings Limited is a member of Bluetooth SIG, Inc. Other trademarks and trade names are those of their respective owners. VTECH TELECOMMUNICATIONS LTD. ...