Page 2 - The DSL filter must; Wall mount
2 Parts checklist Your telephone package contains the following items. Save your sales receipt and original packaging in the event warranty service is necessary. Telephone base and charger installation Install the telephone base and charger as shown below. Use only the power adapters and batteries s...
Page 3 - Battery charging; Battery indicators; Battery installation; THIS SIDE UP; CHARGE; To mount your telephone on a wall:
3 Battery charging Once you have installed the battery, the screen indicates the battery status (see the table below). For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after hours of continuous charging. Battery indicators Battery ...
Page 5 - Settings menu; HH; Then press or to choose; AM; or; PM; Press; SELECT; Telephone operation
5 Using the menu Press MENU when the handset is not in use. Press or until the screen displays the desired feature menu. Press SELECT . To return to the previous menu, press CANCEL . To return to idle mode, press and hold CANCEL . Telephone settings Default settings are indicated by asterisks (*). S...
Page 6 - Use this feature to find all system handsets.; Do not press and hold /; FIND HANDSET; for more than
6 Mute The mute function allows you to hear the other party but the other party cannot hear you. During a call, press MUTE . The screen displays Muted . Press MUTE again to resume the conversation. The screen displays Microphone on briefly. Call waiting When you subscribe to call waiting service fro...
Page 7 - Directory
7 Intercom Use the intercom features for conversations between two handsets. Press INT on your handset when not in use. When you have three or more handsets, use the dialing keys to enter a destination handset number.To answer the intercom call, press , , INT or any dialing key on the destination ha...
Page 8 - Speed dial; Caller ID; the first or second ring.; Caller ID log; About answering system and voicemail
8 Speed dial You can copy up to 9 directory entries into the speed dial locations ( 0 and 2 - 9 ) so that you can dial these numbers using fewer keys than usual. To assign a speed dial entry: Press MENU when the handset is not in use. Scroll to Directory , then press SELECT . Scroll to Speed dial , ...
Page 9 - Answering system settings; “Record after the tone. Press; Answering system operation
9 Answering system settings Default settings are indicated by asterisks (*). Settings menu Description Options Call screening Set whether you hear the callers while they are leaving messages to you. Screening: On*Screening: Off # of rings Set the number of times the telephone rings before the answer...
Page 10 - Add and register a handset; This telephone system accommodates up to five handsets.; To register a handset:; Replace a handset; To deregister all handsets:; light on the telephone base turns on and starts to flash.; Troubleshooting
0 Enter one of the following remote commands. Command Description 1 Play all messages. 2 Play only new messages. 3 Delete the current message (during playback). 33 Delete all old messages. 4 Repeat the current message (during playback). 5 Stop. *5 Hear a list of remote commands. 6 Skip to the next m...
Page 11 - ANS ON; The answering system does not record messages.; MENU; Common cure for electronic equipment.; Important safety instructions
Unplug the electrical power to the telephone base. Wait for approximately 5 seconds, then plug it back in. Allow up to one minute for the cordless handset and telephone base to synchronize. Charge the battery in the handset for up to hours. If the battery is completely depleted, charge the handset f...
Page 12 - SAVE THESE INSTRUCTIONS; Precautions for users of implanted cardiac pacemakers; ECO mode
2 Do not overload wall outlets and extension cords.Unplug this product from the wall outlet and refer servicing to an authorized service facility under the following conditions: When the power supply cord or plug is damaged or frayed.If liquid has been spilled onto the product.If the product has bee...
Page 13 - Limited warranty; Please retain your original sales receipt as proof of purchase.
3 The RBRC ® seal The RBRC ® seal on the nickel-metal hydride battery indicates that VTech Communications, Inc. is voluntarily participating in an industry program to collect and recycle these batteries at the end of their useful lives, when taken out of service within the United States and Canada.T...
Page 14 - FCC, ACTA and IC regulations; Technical specifications; VTECH TELECOMMUNICATIONS LTD.
4 FCC, ACTA and IC regulations FCC Part 15 This equipment has been tested and found to comply with the requirements for a Class B digital device under Part 5 of the Federal Communications Commission (FCC) rules. These requirements are intended to provide reasonable protection against harmful interfe...