Page 2 - IMPORTANT; Please Read and Follow; Table of Contents
IMPORTANT It is the customer’s responsibility to: • Contact a qualified electrical installer.• Read all instructions before using the refrigerator. • Observe all local codes and ordinances. Install refrigerator according to installationinstructions. All connections for water,electrical power and gro...
Page 3 - Refrigerator Safety
IMPORTANT 5 – Please Read and Follow Refrigerator Safety 4 A GFI shall be used if required by NFPA- 70 (National Electric Code),federal/state/local laws, or localordinances. • The required use of a GFI is normally related to the location of a receptacle withrespect to any significant sources of wate...
Page 4 - 6” Professional French Door; Professional French Door Bottom-Mount
Specifications (Professional) 7 Dimensions (Professional) 6 44-3 /16 ” (11 2.2 cm ) 24-3 /4” (62 .9 cm ) 71-7 /8” (18 2.6 cm ) min . to 72-5 /8” (18 4.5 cm ) max . 35-7 /8” (91 .1 cm ) w/s ide pan els acc esso ry 35-5 /8” (90 .5 cm ) 23 -1/ 2” (59 .7 cm ) 26 -1/ 8” (66 .4 cm ) 28 -1/ 8” (71 .4 cm ) ...
Page 5 - 6” Designer French Door; Designer French Door Bottom-Mount
Specifications (Designer) 9 Dimensions (Designer) 8 44-3 /16 ” (11 2.2 cm ) 24-3 /4” (62 .9 cm ) 71-7 /8” (18 2.6 cm ) min . to 72-5 /8” (18 4.5 cm ) max . 35-7 /8” (91 .1 cm ) w/s ide pan els acc esso ry 35-5 /8” (90 .5 cm ) 23 -1/ 2” (59 .7 cm ) 26 -1/ 8” (66 .4 cm ) 28 -1/ 8” (71 .4 cm ) 36” Desi...
Page 6 - Important Safety Instructions; Proper Disposal
11 10 Important Safety Instructions IMPORTANT: Child entrapment and suffocation are notproblems of the past. Junked or abandonedrefrigerators are still dangerous - even if they willsit for “just a few days.” If you are getting rid ofyour old refrigerator, please follow theseinstructions to help avoi...
Page 8 - Doors & Drawer Removal; General Information
15 14 Remove and Replace Handles 1. Using a 3/32"or 1/8” hex wrench, loosen the two set screws located on the side of eachhandle. 2. Pull the handle straight out from the door. Make sure you keep the screws for reattachingthe handles. 3. To replace the handles, reverse the directions. Remove Doo...
Page 10 - Installation; Leveling; Materials Needed
19 18 Installation Connect to Water Line (cont.) 6. Fasten the shutoff valve to the cold water pipe with the pipe clamp. Be sure the outlet end issolidly in the 1/4" drilled hole in the water pipeand that the washer is under the pipe clamp.Tighten the packing nut. Tighten the pipeclamp screws sl...
Page 11 - Door Alignment; Performance Checklist; Complete the Installation
21 20 3 1 2 Remove toe grille. Grasp firmly and pull outward to unclip. To raise left side door, turn leveler foot screw clockwise. Door Alignment (French Door Bottom-Mount) To raise left side door, turn leveler foot screw clockwise. 4 Replace toe grill. Align the toe grille mounting clips with the ...
Page 12 - Service & Registration; Notes
23 22 Service & Registration Only authorized replacement parts may be used in performing service on the appliance.All servicing should be referred to a qualified technician. Contact Viking Range Corporation, 1-888-VIKING1 (845-4641), for the nearest service partsdistributor in your area or write...