Page 2 - container below. The cream mouth can be twisted at will (PIC3)
PIC2 2 Align the hole at the bottom of the container with the electric separator. The "Dong" sound when the rotary installation is tightened indicates that it has been fully installed (PIC2) 3 Press tightly and tie the skimmed milk mouth and the cream mouth to the container below. The cream ...
Page 5 - The operation steps are as follows:; Pour about one third of the 60°C water into the milk pot container.
II .Operation Steps The operation steps are as follows: 1 Pour about one third of the 60°C water into the milk pot container. 2 Put the power on and switch on the separator to make the motor work. ③ After the separator works for 1 minute, slowly turn the milk container switch(Metal Rod)anticlockwise...
Page 6 - The Milk Fat Concentration Adjusting; according to the following steps:; milk in the milk pot container.; Cleaning Steps; The cleaning steps are as follows:; The milk pot container only needs to be removed in order and washed
Page 8 - Common Faults and Eliminating Methods; Fault
PIC10 V. Common Faults and Eliminating Methods Common Faults and Eliminating Methods (Each reason corresponds to each method) Fault Conditions Causes Eliminating Methods Poor Separation Performance 1. Milk temperature too low or too high. 2. Milk is too sour. 3. Milk is not clean. 4. The copper nut ...
Page 9 - DC or 12V DC after voltage transformation can be used.
The butterfat is too thin or the fat hole gives milk 1. The butterfat is too thin. 2. The height of the separating bowl is not correct. 1. Adjust the screw and turn it to the left. 2. Adjust the height of the separating bowl. The separator overflows or the hole leaks a lot of milk. 1. At the beginni...