Uniden UBC 61XLT - Manuals - manualsarea.com

Page 2 - WARNING

2 UBC 61 XLT Programmable Hand-Held Scanner Introduction What is Scanning?The UBC61XLT scans programmed channels untilit finds an active frequency. Scanning stops on an active frequency andremains on that channel as long as the transmis-sion continues. When the transmission ends, thescanning cycle r...

Page 4 - SETUP; Installing the Batteries; Note: If you are installing alkaline batteries, set the; Optional Accessories; Cigarette Lighter Lead

SETUP Installing the Batteries 1.Open the cover 2.Insert Batteries Note: If you are installing alkaline batteries, set the switch to REG. ALK.BATT. If installing nickel-cadmium batteries, set the switch to Ni-Cd BATT. 3.Replace cover and press down until it clicks into place. Do not mix alkalinebatt...

Page 5 - Basic Operation; Think of Squelch Control as a gate. Turn; Turn SQUELCH fully clockwise until you hear a

5 Basic Operation Setting the SquelchTo set the squelch, you must be in the manualmode.No signal should be present when adjustingsquelch. 1. Press until you do not hear a signal. 2. Adjust VOLUME to a comfortable listening level. 3. Think of Squelch Control as a gate. Turn SQUELCH fully counter-cloc...

Page 6 - ERROR

6 Programming Before the UBC61XLT can receive radio broad-casts, you must program a frequency into at leastone channel before scanning, repeat this procedurefor each channel you program.Up to 80 channels may be programmed 1. Select frequencies 2. Press 3. Select a channel a) Enter the channel number...

Page 7 - Channel Lockout

7 Channel Lockout You can lockout any channel so it is not reviewedduring normal scanning. You can restore the chan-nel to scanning whenever you wish. Lockout in Manual Mode1. Press 2. Select a channel a) Enter the channel number b) Then press again. 3. Press to lockout the channel. Locking a Channe...

Page 8 - Priority Scan; Press again; P ch Loc Out

8 3. Press to unlock the channel. Restore All Locked-out Channels1. Press You must be in manual mode before restoring all locked-out channels.2. Press and hold for about two seconds. You will hear twobeeps when all thechannels have beenrestored. Empty chan-nels cannotbe deleted and are alwayslocked ...

Page 9 - Chain Search; and

9 3. Press and hold for two seconds to desig-nate this channelas your new priority channel. Two beeps indicatethat the priority channel is changed. Chain Search Use chain search to find active frequencies in yourarea. You can search up to all five personal bandsor turn off those bands you don’t want...

Page 11 - CAUTION

11 1. Press either or during a search. You must bein search hold before restoring allskipped frequencies. 2. Press and hold for about two seconds. You will hear two beeps when all the frequencies have been restored. Storing Search FrequenciesYou can quickly store any frequency you find duringsearch....

Page 12 - Troubleshooting; Problem; Warranty

12 Troubleshooting If your UBC61XLT is not performing properly, try the following steps. Problem Suggestion Improper reception 1. Check the antenna connection or move and reposition the antenna.2. Move the scanner3. You may be in a remote area which could require an optional multiband antenna. Check...