TRENDNet TEW-AI86D - Manuals

Page 2 - Table of Contents

Table of Contents English ..................................................................................... Troubleshooting ........................................................................ 1 1 2 7 1. Before You Start2. Hardware Installation ..................................................

Page 3 - Before you start; The antenna can tilt 0° to 180° and rotate 360° .; Wall / partition mount (Antenna base with embedded; Package Content; Product details

1. Before you start English 1 WARNING: The antenna can tilt 0° to 180° and rotate 360° . The Internal antenna wire is fixed, therefore do not rotate the antenna beyond 360° . Wall / partition mount (Antenna base with embedded magnets) For antenna deployment, you can mount the antenna onto a wall usi...

Page 4 - Hardware installation; Due to the bi-directional nature of WiFi; Recommended devices to connect with this antenna; Wireless PCI adapter or IP Camera with detachable Antenna

English 2 2. Hardware installation Wireless base stations with detachable antenna(s): As a method of focusing signal broadcast to achieve longer range coverage in your home or office, the antenna generates an 80° wide directional signal. Due to the bi-directional nature of WiFi devices (receive / tr...

Page 5 - Recommended installation positions

TEW-AI86D antenna has directional 80° signal coverage. Therefore, the ideal position for the antenna is in the corner of the covered area. Recommended installation positions English 3 TEW-AI86D antennas can also be placed at the side / edge of the covered area for long range hall / corridor transmis...

Page 6 - Antenna Base Mounting Methods & Configuration; Please make sure that the AP / Client device; In order to decrease the weight and increase the

English 4 Antenna Base Mounting Methods & Configuration PLEASE READ THE FOLLOWING INSTALLATION STEPS BEFORE DRILLING HOLES IN THE WALL. After removing the bottom cover from its seating, remove the metal weight plate from the ceiling clips to expose the screw holes. Press Tab Lift Cover Remove we...

Page 7 - Ceiling Mount Using Ceiling Clips or Magnets

English 5 After drilling holes in the drywall / gypsum / plasterboard, sink the plastic anchor into the hole (1/8 inch drill bit (3mm)). Leave about 3 to 5mm (1/8 inch) of the threaded screw exposed as depicted in the diagrams below. The special ceiling mount feature is mainly recommended for use wh...

Page 8 - If the ceiling tees are made of steel, turning the; Press tab and lift

English 6 How to assemble the antenna stand for use with ceiling systems. Note: If the ceiling tees are made of steel, turning the antenna base cover over may not be necessary, because the base has embedded magnets which can be used to adhere the antenna to the ceiling tee. Press tab and lift Turn o...

Page 9 - Troubleshooting; The TEW-AI86D is a directional antenna and can only send and

7 Troubleshooting Certifications This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference.(2) This device must accept any interference received. Including interference that may c...

Page 10 - Limited Warranty

8 Limited Warranty TRENDnet warrants its products against defects in material and workmanship, under normal use and service, for the following lengths of time from the date of purchase. TEW-AI86D/TEW-AI86DB - 3 Years Warranty If a product does not operate as warranted above during the applicable war...

Page 12 - TRENDnet Technical Suppor t; US/Canada Support Center; European Support Center; Product Warranty Registration

Copyright ©2006. All Rights Reserved. TRENDnet. 3135 Kashiwa StreetTorrance, CA 90505USA TRENDnet Technical Suppor t US/Canada Support Center Tech Support Hours 24/7 Toll Free Tech Support Contact Telephone: 1(866) 645-3673 Email: [email protected] European Support Center Contact Tech Support Hou...