TRENDNet S4W1CA - Manuals - manualsarea.com

Page 2 - TABLE OF CONTENTS

TABLE OF CONTENTS About This Guide ...............................................................................................................1 Purpose ..........................................................................................................................1 Overview of this Use...

Page 5 - UNPACKING AND SETUP

5 UNPACKING AND SETUP This chapter provides unpacking and setup information for the Broadband Router. Unpacking The box should contain the following items: One 4-port High Speed Broadband Router One external power adapter (5V DC, 800mA) One CD-ROM with User’s Guide Quick Installation Guide I...

Page 7 - Hardware connections; Connect the Internet Broadband Router

9 Hardware connections Connect the Internet Broadband Router 1. Connect one end of the network cable to the WAN port of the 4-port Internet Broadband Router. 2. Connect the other end of the network cable to the Ethernet port of the xDSL or Cable modem. 3. Connect one end of another network cable to ...

Page 12 - in the Primary DNS address fields. You may also enter another

19 control the connection time (default time=0, always connect). Check the Connect-on-demand box to enable your router to connect your ISP whenever an Internet connection is required. 1-3 DNS The Domain Name System (DNS) is the way that Internet domain names are translated into Internet Protocol (IP...

Page 14 - Enable

23 2-1-7 Reset 2-2 WAN The Broadband Router supports the following types of Internet connections: Dynamic IP Address, Static IP Address, PPPoE, and PPTP. 2-2-1 Dynamic IP The Host Name is optional, but may be required by some Service Providers. The default MAC address is set to the WAN's physical in...

Page 15 - If your ISP provided at least one DNS Server IP Address, type that; IP

25 The MTU feature specifies the largest packet size permitted for network transmission. Enter the value desired; for most DSL users, 1492 is recommended. By default, MTU is set at 1492. The Maximum Idle Time feature can control the connection time (default time=0, always connect). Check the Connect...

Page 16 - Password; To set the LAN’s IP Address.

27 Enter the username provided by your Dynamic DNS service provider. • Password Enter the password provided by your Dynamic DNS service provider. 2-3 LAN To set the LAN’s IP Address. 2-3-1 LAN Settings The default value is 192.168.0.1 for the IP address and 255.255.255.0 for the Subnet Mask. You may...

Page 18 - To block certain client PCs from accessing the Internet:

31 2-5 Firewall The Broadband Router provides extensive firewall protection by restricting connection parameters to limit the risk of hacker attacks and by defending against a wide array of common hacker attacks. The Broadband Router provides packet filtering rules by restricting service ports, IP a...

Page 19 - TECHNICAL SPECIFICATIONS; General

33 2-5-4 DMZ (Demilitarized Zone) If a local client PC cannot run an Internet application properly from behind the NAT firewall, open the client up to unrestricted two-way Internet access by defining a PC as a virtual DMZ Host. 2-6 Routing 2-6-1 Static Routing Static routing determines the path that...