TRAXXAS 71074 - Manuals

1 / 1 6 E - R E V O V X L • 5 TOOLS, SUPPLIES, AND REQUIRED EQUIPMENT Your model comes with a set of specialty metric tools. You’ll need to purchase other items, available from your hobby dealer, to operate and maintain your model. Recommended Equipment These items are not required for the operation...

1 / 1 6 E - R E V O V X L • 7 The following guide is an overview of the procedures for getting your model running. Look for the Quick Start logo on the bottom corners of Quick Start pages. 1. Read the safety precautions on page 4 8. Range test the radio system • See page 14 For your own safety, unde...

8 • 1 / 1 6 E - R E V O V X L TRAXXAS TQ 2.4GHz RADIO & VELINEON POWER SYSTEM INTRODUCTION Your model includes the TQ 2.4GHz transmitter. When powered on, the TQ 2.4GHz will automatically locate and lock onto an available frequency, allowing multiple models to be raced together without frequency...

1 / 1 6 E - R E V O V X L • 9 TRAXXAS TQ 2.4GHz RADIO & VELINEON POWER SYSTEM allow higher capacity than NiCad batteries. They can last up to 500 charge cycles. A peak charger designed for NiMH batteries is required for optimal performance. Receiver - The radio unit inside your model that receiv...

10 • 1 / 1 6 E - R E V O V X L TRAXXAS TQ 2.4GHz RADIO & VELINEON POWER SYSTEM VXL-3m Wiring Diagram MOTOR MOTOR To Motor LED EZ-Set Button Heat Sinks High-Current Battery Connector KA186 7-R00 KA186 7-R00 CH3 - Channel 3* CH2 - Speed Control CH1 - Steering Servo CH1 - Channel 1* Antenna Receive...

1 / 1 6 E - R E V O V X L • 11 2-5 Use the Right Batteries Your transmitter uses AA batteries. Use new alkaline batteries or rechargeable batteries, such as NiMH (nickel-metal hydride) batteries, in your transmitter. Make sure rechargeable batteries are fully charged according to the manufacturer’s ...

12 • 1 / 1 6 E - R E V O V X L The following Traxxas High-Current Connector packages are available from your hobby dealer. When using adapters, be careful not to exceed the current rating of the Molex connector. Part #3060 Single Male/Female Part #3080 2-Pack Female Part #3070 2-Pack Male Part #3061...

1 / 1 6 E - R E V O V X L • 13 TRAXXAS TQ 2.4GHz RADIO & VELINEON POWER SYSTEM Remember, always turn the transmitter on first and off last to avoid damage to your model. When rechargeable batteries begin to lose their charge, they will fade much faster than alkaline dry cells. Stop immediately a...

14 • 1 / 1 6 E - R E V O V X L USING THE RADIO SYSTEM The TQ 2.4GHz Radio System has been adjusted at the factory for correct operation with your model. The adjustment should be checked before running the model, in case of movement during shipping. Here’s how: 1. Turn the transmitter switch on. The ...

1 / 1 6 E - R E V O V X L • 15 Higher Speeds Require Greater Distance The faster you drive your model, the more quickly it will near the limit of radio range. At top speeds, models can cover anywhere between 50 to 100 feet every second! It’s a thrill, but use caution to keep your model in range. If ...

16 • 1 / 1 6 E - R E V O V X L The electronic speed control is factory set and should not require any adjustments. These instructions are provided for your reference. Setup Programming (Calibrating your ESC and transmitter) Read through all of the following programming steps before you begin. If you...

1 / 1 6 E - R E V O V X L • 17 Selecting Sport Mode (Profile #1) 1. Connect a fully charged battery pack to the ESC and turn on your transmitter. 2. With the ESC off, press and hold the EZ-Set button until the light turns solid green, then solid red, and then begins blinking red (indicating the Prof...

18 • 1 / 1 6 E - R E V O V X L DRIVING YOUR MODEL Now it’s time to have some fun! This section contains instructions on driving and making adjustments to your model. Before you go on, here are some important precautions to keep in mind. • Allow the model to cool for a few minutes between runs. This ...

20 • 1 / 1 6 E - R E V O V X L DRIVING YOUR MODEL • Transmission : Remove, disassemble, and clean the transmission components. No grease is required for the nylon gears. Refer to your exploded view diagrams for help with disassembly and reassembly. • Motor : Remove the motor, clean with aerosol moto...

1 / 1 6 E - R E V O V X L • 21 TUNING ADJUSTMENTS Your model is factory-tuned for optimum performance on pavement and concrete surfaces. To tailor the performance and handling of your model to suit your driving style and available traction, your model has a number of adjustable features. Gearing, sh...

22 • 1 / 1 6 E - R E V O V X L TUNING ADJUSTMENTS A camber gauge (available at your local hobby shop) can be a useful tool for alignment setting. To achieve a good starting point for the slipper clutch, tighten the slipper clutch adjusting nut clockwise until the slipper clutch adjusting spring full...

1 / 1 6 E - R E V O V X L • 23 TUNING ADJUSTMENTS TRANSMISSION TUNING Adjusting the Slipper Clutch Your model is equipped with an adjustable Torque Control slipper clutch, which is built into the large spur gear. The purpose of the slipper clutch is to prevent over-stressing of the drivetrain and tr...

24 • 1 / 1 6 E - R E V O V X L Spur Gear Pinion Gear 45 50 55 11 - - 25.20 12 - - 23.10 13 - - 21.32 14 - - 19.80 15 - - 18.48 16 - 15.75 17.33 17 - 14.82 16.31 18 - 14.00 15.40 19 - 13.26 14.59 20 - 12.60 13.86 21 10.80 12.00 13.20 22 10.31 11.45 12.60 23 9.86 10.96 12.05 24 9.45 10.50 11.55 25 9.0...

1 / 1 6 E - R E V O V X L • 25 High Speed Gearing The included high-speed pinion gear can be installed to increase the top speed of your model to 50+mph. This also requires the use of an additional battery (sold separately) and a Traxxas series connector (Part #3063, sold separately). See page 12 fo...

26 • 1 / 1 6 E - R E V O V X L 1 1 If you have questions or need technical assistance, call Traxxas at 1- 8 8 8 - T R A X X A S (1-888-872-9927) (U.S. residents only) MAINTAINING YOUR MODEL Your model requires timely maintenance in order to stay in top running condition. The following procedures sho...