Toshiba LF470- Manuals

Toshiba LF470– Manual in PDF format online.

Manuals:

Manual Toshiba LF470

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9

Summary

Page 2 - Two outputs (DO1 and DO2) are needed for

LF470/LF622 2 MAX:17W(24VA) with PROFIBUS Model LF470 Detectors Fluid pressure: -0.1 to 1 MPa Pipe connection port: Standard – Rc (PT) 1/4 thread Option – See Table 4 Principal materials: Measurement tube – Alumina ceramics Electrodes – Platinum Pipe connection port: Standard – 316 stainless steel O...

Page 3 - Consumption electric current of bus:less than 16mA; Avoid using the flowmeter in an

LF470/LF622 3 Communications output: ・ HART(std.) Digital signal is superimposed on 4–20mAdc current signal as follows: Conforms to HART protocol Load resistance: 240 to 750 Load capacitance: 0.25µF maximum Load inductance: 4mH maximum • PROFIBUS(opt.) Protocol : PROFIBUS-PA Baurate : 31.25kbps Bus ...

Page 4 - Installation; Dimensions; Figure4. LF470 Mounting Board; Cable glands are not provided for LF622F cFMus approved type.

LF470/LF622 4 Installation Dimensions If a mounting plate is needed for the LF470, fix the plate (a) above to the bottom of the LF470. Depending on which pair of screw holes used, the mounting angle changes by 90 ° . Figure3. LF470 Dimensions 30 (1.18) 75 (2.95) 86 (3.39) ** ** * * 2-φ6 (φ0.24) hole...

Toshiba Manuals