Tiger Shark - Manuals - manualsarea.com

Page 2 - Important Note To Parents About Safe Riding; This scooter was not designed for racing or performing tricks.

Important Note To Parents About Safe Riding Your child's safety will depend on your commitment to always provide a safe riding environment and a properly maintained vehicle. As with any moving vehicle there are possible safety risks; be sure to heed to the following precautions. 1. Always equip your...

Page 3 - Turn the power switch to the

Safety Precautions 1. Review all the instructions carefully before operations. 2. Follow all rules and regulations in your area for operating an electric scooter. 3. Do not allow others to use the scooter without proper instructions. 4. Ride only in good weather, on smooth surfaces. 5. Remember to a...

Page 5 - Assembly Instructions; Carefully take your scooter out of the box.

Assembly Instructions 1. Carefully take your scooter out of the box. 2. Assemble the Handle Bar. a. Remove the bolt from the base of the Handle Bar and position the top part of the Handle Bar on to the base and tighten the bolt. b. Lift Handle Bar into upright position and tighten star screw. 5

Page 8 - Change the Rear Tire; Remove the axle bolts located on both sides of the rear tire.; Rear Tire

Change the Rear Tire • Tools Required: - Phillips screwdriver - 8mm wrench - 2 x 16mm wrench Step Description 1 Ensure power switch is in the "off" position before beginning any work on the scooter. 2 Remove screw holding brake shield in place located next to the left side of the rear tire. ...

Page 9 - Disconnect the wires, by loosening the bolts.

Change the Motor Step Description 1 Remove the deck. 2 Disconnect the wires, by loosening the bolts. 3 Unscrew the 2 bolts that secure the motor, as pictured below, and remove the motor. 9

Page 10 - To tighten chain, turn the 8mm nut on the eyebolt counter clockwise

Adjust the Chain Step Description 1 Loosen axle bolt. 2 To tighten chain, turn the 8mm nut on the eyebolt counter clockwise 3 To loosen the chain, turn the 8mm nut on the eyebolt clockwise. 10

Page 12 - Battery is discharged.

Troubleshooting Chart Problem Cause Solution The power light by the on/off switch does not light up when the scooter is turned on? 1. Battery is discharged. 2. Loose connection inside the scooter. 1. Recharge your scooter. 2. Remove (3) screws that hold the deck on and remove the deck. Visually insp...

Page 15 - . State the specific

Rad2Go Electric Scooter Warranty This Warranty Registration is to be completed by the dealer or customer at the time of purchase and submitted to Rad2Go, Inc., within 10 days of the date of purchase for warranty entitlement. This warranty is void if the serial number or the safety warning labels on ...

Page 16 - Purchaser herewith acknowledges

nature and any circumstances leading to the problem. A service technician will contact you with specific instructions to ensure that you receive the best service for your scooter in the most economical way. 5. Purchaser herewith acknowledges : a. That Rad2Go assumes not liability for any misuse or i...