Thomson ASR08T - Manuals - manualsarea.com

Page 2 - ENGLISH; Impor tant safety and operating information.

3 ENGLISH Impor tant safety and operating information. This set was designed and manufactured in accordance with international safety standards. You must nonetheless observe certain rules to guarantee optimum results and safety. Read this user manual before attempting to put the set into service. En...

Page 3 - CONTENTS; Page

4 ENGLISH CONTENTS Page REMOTE CONTROL UNIT .................................................................................... 5 FRONT PANEL KEYPAD ....................................................................................... 6 REAR PANEL CONNECTIONS.........................................

Page 4 - REMOTE CONTROL UNIT; STANDBY key (Switch set on using the

5 ENGLISH REMOTE CONTROL UNIT STANDBY key (Switch set on using the CH M /CH N keys, or 0 to 9) Parental lock.Numeric keypad :- Channel selection - Frequency entry - Toturn on the receiver. Channel scrolling (zapping) and to turn on the receiver. To interchange two programme numbers. Video level sele...

Page 5 - FRONT PANEL KEYPAD; Programme number display; Channel scrolling keys

6 ENGLISH TV DECODER VCR L R IF INPUT MADE INGERMANY A B WARNING!Shock HazardDo not open j Mains socket to connect the set to the ac power supply. g SCART socket to connect a decoder e IF B input - socket to connect a second LNB (e.g. EUTELSAT II - F1/HOTBIRD) f SCART socket to connect the televisio...

Page 6 - INSTALLATION OF SATELLITE RECEIVER

7 ENGLISH A correctly installed satellite antenna is essential for the receiver to operate. The satellite antenna coaxial cable must be long enough to reach the desired receiver site.Install the receiver near your television set, making sure to leave ventilation space of about15 cm to the sides and ...

Page 8 - GH; EVERYDAY USE

9 ENGLISH On/StandbyUsing set keypad:Press the On/Standby key. Using remote control:Switch the receiver on by pressing one of the numeric keys (0 to 9), or on the remote control keypad. If the set is switched on using the or keys, the last programme number active before switching off is called up, f...

Page 9 - RECORDING SATELLITE PROGRAMMES; You can leave the satellite receiver on without any problem.

10 ENGLISH RECORDING SATELLITE PROGRAMMES If your receiver is connected to a VCR, you can record satellite programmes. Paragraph 2 : Connection to a VCR in the INSTALLATION OF SATELLITE RECEIVER chapter of thepresent manual describes the procedure for connecting the VCR to the receiver.Refer also to...

Page 10 - Selection of LNB and of ToneBurst signal; PROGRAMMING A NEW CHANNEL

11 ENGLISH Your receiver is already programmed to receive the most important satellite signals. You can, however, change the programming or add new channels at any time.To store a new channel in memory, you need the following information (found in specialistsatellite TV magazines): 1. LNB selection ...

Page 11 - DISPLAY

12 ENGLISH PROGRAMMING A NEW CHANNEL 4. Audio mode selectionPress the key to display the audio mode, e.g. : "Ton1". Press several times to display all the available modes. DISPLAY MODE DE-EMPHASIS BANDWIDTH "Ton 1" Stéréo Wegener Panda 130 kHz "Ton 2" Mono Wegener Panda 130 k...

Page 12 - Press the key again to select the second mode.; SPECIAL FEATURES; Display

13 ENGLISH 1. Video LevelThis feature lets you adjust the video level to compensate for differences in level that mayexist between the various satellites.Press the key to display the current mode, e.g. : " HI ". Press the key again to select the second mode. " HI " = light image (16 ...

Page 13 - Press again to select the second mode.

14 ENGLISH 4. 22 kHz Switching SignalThis signal can be used to control either a switching box or, for example, the LNB (highband/low band).Press the key briefly to display the current mode, e.g. : "22-". Press again to select the second mode. "22 +" = 22 kHz switching signal in serv...

Page 14 - C O N V E N I E N C E F E AT U R E S; Press the

15 ENGLISH C O N V E N I E N C E F E AT U R E S 1. Parental LockUsed to restrict use of the set, or access to certain programmes.1. Locking certain programmes. The programme can be selected, but the picture does not appear on screen.The programming cannot be altered. Locked programmes are indicated ...

Page 15 - T R O U B L E S H O O T I N G; SYMPTOM; S P E C I F I C AT I O N S

16 ENGLISH T R O U B L E S H O O T I N G SYMPTOM POSSIBLE CAUSE Display inoperative - Mains lead incorrectly connected- Power cut Unable to switch set on - Short circuit in the coaxial cable connected to the LNB No picture - SCART cable incorrectly connected.- Wrong LNB selection. No sound - Poor ad...

Page 16 - - 32 KEYS WITH NUMERIC KEYPAD

17 ENGLISH RF PART - INPUT FREQUENCY : 900-2150 MHz (IN STEPS OF 1 MHz) - INPUT IMPEDANCE : 75 OHM - INPUT LEVEL : -60 dBm -30 dBm- INTERMEDIATE FREQUENCY : 479.5 MHz - RESPONSE THRESHOLD : 6 dB VIDEO PART - DE-EMPHASIS : CCIR REC 405-1, 625 LINES - FREQUENCY RESPONSE : 50 Hz - 4,0 Mhz (+1,5 dB / - ...