Telex MS2002 - Manuals - manualsarea.com

Page 2 - FCC Statement

2 FCC Statement This equipment uses, and can radiate radio frequency energy that may cause interference to radiocommunications if not installed in accordance with this manual. The equipment has been testedand found to comply with the limits of a Class A computing device pursuant to Subpart J, Part 1...

Page 3 - Contents

3 Contents Description .............................................................................................................. 4 Features ................................................................................................................... 4 Installation ...........................

Page 4 - unbalanced dynamic microphone.

4 Description The MS-2002 is a complete 2-channel master station and system power supply (24 V DC, 2 Amps total power) in asingle unit. You simply plug it into any AC power outlet from 100 to 240 volts, add a microphone or headset, connectintercom stations to the back panel, and you’re ready to comm...

Page 6 - Installation; Unpacking; Q y; Configuration Pre-check

6 Installation Unpacking The package contains the following items. Contact the shipper or your Audiocom dealer immediately if anything isdamaged or missing. Detach and fill out the registration card and return it to Telex to properly register yourMS-2002. y t Q y t Q y t Q y t Q y t Q n o it p i r c...

Page 9 - For binaural operation with two speakers:; Balanced/Unbalanced Switches; Mounting

9 For binaural operation with two speakers: 1. Set SW3-2 to on. 2. Set SW3-5 to off. 3. Set SW3-6 to on. 4. Set SW3-7 to off. 5. Set SW3-8 to off. Balanced/Unbalanced Switches Both of the BAL - UNBAL Switches on the back panel are set at the factory to the balanced (BAL) position for usewith Audioco...

Page 10 - Cables

10 Cables The numbers below correspond to the cable numbers in the connection drawings on the following pages. 1. 1-channel intercom cable. Sold separately. Use Telex “ME” cables, below. Or, build per Figure 7, page 14. ME-25: 25' (7.6 m) cable with Male and Female 3-pin XLR connectors.ME-50: 50' (1...

Page 16 - Test Tone; or intercom station where the test tone is being lost.; Sidetone Adjustment; channel 2. Talk key to turn it off when finished.

16 Power-Up Check Plug in the MS-2002. When power is first applied to the MS-2002, it will perform a power-up reset, in which thefront panel indicators will cycle through all of their possible colors and then turn off. This verifies the generaloperation of the intercom station and indicators. The MS...

Page 17 - Check and set the level as follows:; Operation; Note

17 Figure 8 - MS-2002 Bottom View Voice-Activated Microphone (Vox) Setup If you are going to use vox, you must adjust the vox level for proper operation. If the vox level is too low, roomnoise will activate the microphone. If the Vox level is too high, the microphone will not activate when you begin...

Page 19 - Turning the Program Inputs On and Off; Using Mic Kill; Incoming Call Beep On/Off

19 Public Address (PA) If the PA output on the back panel of the MS-2002 is connected to a public address system, you can talk on thepublic address system as follows: 1. If you are using manual microphone activation instead of Vox, make sure the proper microphone switch is turned on (either Headset ...

Page 20 - Specifications; General; MS2002 is capable of supplying 2 amps overall; Panel Microphone Input

20 Specifications General Power Requirements: AC Input: 100-240 VAC, 50/60 HzChannel Power: 24 VDC nominal (12 to 30 VDC), 65 to 150 mA MS2002 is capable of supplying 2 amps overall Dimensions: 1.75" (44.5 mm) high x 19" (483 mm) wide x 10.31" (261.9 mm) deepWeight: approximately 4.5lb (...

Page 21 - XLR-6 Balanced Configuration Pinouts

21 Intercom Channels, Balanced Mode (Both Back Panel and internal switches (BAL/UNBAL) must be set to same setting) Output Level: 1 Vrms nominalInput Impedance: 300 ohmsBridging Impedance: greater than 10,000 ohmsSidetone: -40 dB, 35 dB adjustable rangeCall Signaling: Send: 20 kHz ±100 Hz, 0.5 Vrms ...

Page 22 - PA Output

22 XLR-3 Unbalanced Configuration Pinouts Pin 1: CommonPin 2: +24 VDC inputPin 3: Intercom audio high XLR-6 Unbalanced Configuration Pinouts Pin 1: CommonPin 2: Local power (12 to 15 VDC, 65 to 150 mA)Pin 3: Channel 1 +24 VDC inputPin 4: Channel 1 Intercom audio high and DC callPin 5: Channel 2 +24 ...

Page 23 - Quick Reference

23 D D D D D E E E E ESCR IPTION A A A A A C C C C CTION 2 0 0 2 - S M t e s e R 1 n e t s i L d n a k l a T l l A s s e r P 1 0 0 4 S M E t e s e R 5 n e t s i L d n a k l a T l l A s s e r P n o l a n g i s t s e T l l a C p a t n e h t , A P d n a k l a T l l A s s e r P f f o l a n g i s t s e T...