Tannoy Highline 500 - Manuals

Page 2 - Please ensure no bare wire touches the metal cabinet.

CONTENTS INTRODUCTION 3 SATELLITEWhat’s in the box? 4 How to wall mount 5 STAND MOUNTWhat's in the box? 8 How to stand mount 9 CENTRE CHANNELWhat’s in the box? 10 How to wall mount 11 TOWERWhat’s in the box? 13 How to connect 14 ROOM SET UP 15 CONNECT TO RECEIVER 16 SPECIFICATIONS 17 WARRANTY This e...

Page 4 - Required but not included:

SATELLITEWhat’s in the box? 1 x Satellite speaker 1 x Long wall bracket 1 x Short bracket with pre-fitted cap 1 x Short bracket without pre-fitted cap 1 x Bracket cap 4 x 8mm Silver hex socket fixing screw + lock washers 1 x 5mm black cap head fixing screw + spring washer 1 x Ball nosed Allen key Re...

Page 5 - Use a spirit level to ensure the bracket is fitted level.

SATELLITEHow to wall mount WARNING: It is your responsibility to ensure that the bracket to wall fixing screws or bolts and the walls themselves are strong enough to support the weight of the speaker – refer to the speakerweight specifications supplied in this manual. Particular care is needed when ...

Page 6 - Ensure cap is fully engaged with wall bracket

SATELLITEHow to wall mount - continued Cut the speaker wire so that the (+) side is slightly longer than the (-) side andfeed the speaker wire through spare bracket cap. Important Note: It is essential that the speakers are wired correctly at this stage. The (-) wireshould have a solid black line, o...

Page 9 - Important Note

STAND MOUNTHow to stand mount Attach the spike kits, or rubber feet, to the bottom of the stand then thread the cablethrough the stand base and shaft. Cut the speaker wire so that the (+) wire is slightly longer than the (-) wire. Screw the (+) wire into the red terminal and screw (-) wire into blac...

Page 11 - Important note

CENTRE CHANNELHow to wall mount WARNING: It is your responsibility to ensure that the bracket to wall fixing screws or bolts and the walls themselves are strong enough to support the weight of the speaker- refer to the speaker weight specifications supplied in this manual. Particular care isneeded w...

Page 12 - Ensure cap is fully engaged with the wall bracket.

CENTRE CHANNELHow to wall mount - continued Offer the speaker up to the wall bracket half way along. Engage speakerwith bracket and slide across. Ensure cap is fully engaged with the wall bracket. Fix spare cap to bottom of bracket using the cap screw and spring washer provided. 12

Page 13 - Sufficient cable for your requirements

13 TOWERWhat’s in the box? 1 x Tower speaker 6 x Spikes 6 x Rubber Feet 6 x M6 Nuts Required but not included: Sufficient cable for your requirements

Page 14 - : It is essential that the speakers are wired correctly stage.

TOWERHow to connect Attach the spike kits or rubber feet to the base of the tower then thread the speakercable through the base. Cut the speaker wire so that the (+) wire is slightly longer than the (-). Screw the (+) wire into the red terminal and screw (-) wire into the blackterminal. Important No...

Page 15 - ROOM SETUP

ROOM SETUP A 5.1 surround sound system consists of 5 separate speakers and 1 subwoofer.The centre channel is designed to reproduce most of the dialogue or solo performances.The front left and right speakers reproduce the left/right stereo information and specialeffects. The rear left and right speak...

Page 16 - CONNECTING THE SYSTEM TO YOUR AV RECEIVER

CONNECTING THE SYSTEM TO YOUR AV RECEIVER Wire up the system connecting each speaker to the appropriate terminals onthe receiver or amplifier making sure that cables connect red to red terminals(+ to +) and black to black terminals (- to - ). Please note : (+) is shown as grey, (-) is shown as white...

Page 17 - TECHNICAL SPECIFICATIONS; ARENA HIGHLINE 500 CENTRE

TECHNICAL SPECIFICATIONS ARENA HIGHLINE 500, CENTRE & SATELLITE SPEAKER PERFORMANCE: Recommended amplifier power 25 - 100W RMS Maximum sensitivity (2.83V @ 1m) 88dB Nominal impedance 8 Ohm Frequency response (-6dB) 85Hz- 54kHz Drivers 1 x 100mm (4”) Dual Concentric TM with 19mm (0.75”) HF1 x 100...

Page 18 - ARENA HIGHLINE 500 SATELLITE ACCESSORY STAND; Weight

209.0mm (8.23”) 197.0mm (7.76”) 759.5 (29.90”) 999.5 - 1199.5mm (39.35” - 47.22”) TECHNICAL SPECIFICATIONS ARENA HIGHLINE 500 SATELLITE ACCESSORY STAND Weight 5.9kg (13lbs) Dimensions H x W x D 760 x 209 x 197mm(29.90 x 8.23 x 7.76 ins) Finish Black gloss or silver gloss 18

Page 19 - ARENA HIGHLINE 500, TOWER SPEAKER PERFORMANCE:

209.0mm (8.23”) 197.0mm (7.76”) 1160.5mm (45.69”) TECHNICAL SPECIFICATIONS ARENA HIGHLINE 500, TOWER SPEAKER PERFORMANCE: Recommended amplifier power 25 - 100W RMS Maximum sensitivity (2.83V @ 1m) 88dB Nominal impedance 8 Ohm s Frequency response (-6dB) 75Hz- 54kHz Drivers 1 x 100mm (4”) Dual Concen...