Page 2 - Trademarks and copyright
TANDBERG 3G Gateway User Manual Trademarks and copyright All rights reserved. This document contains information that is proprietary to TANDBERG. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form, or by any means, electronically, mechanically, b...
Page 4 - Environmental Issues; TANDBERG’s Environmental Policy
TANDBERG 3G Gateway User Manual Environmental Issues Thank you for buying a product which contributes to a reduction in pollution, and thereby helps save the environment. Our products reduce the need for travel and transport and thereby reduce pollution. Our products have either none or few consumab...
Page 5 - Operator Safety Summary
TANDBERG 3G Gateway User Manual Operator Safety Summary For your protection, please read these safety instructions completely before operating the equipment and keep this manual for future reference. The information in this summary is intended for operators. Carefully observe all warnings, precautio...
Page 6 - Contact us
TANDBERG 3G Gateway User Manual Contact us If you have any questions, comments or suggestions, please see the Online Support service at www.tandberg.net . It is also possible to send a fax or mail to the attention of: Product and Sales Support TANDBERG P.O. Box 92 1325 Lysaker Norway Tel: +47 67 125...
Page 7 - Table of Contents
TANDBERG 3G Gateway User Manual Table of Contents 1 Introduction ................................................................................................................................8 1.1 The TANDBERG 3G Gateway ................................................................................
Page 8 - Introduction
TANDBERG 3G Gateway User Manual 1 Introduction The TANDBERG 3G Gateways enable sites on IP and UMTS Handsets to participate in meetings with each other with the quality and reliability found in all TANDBERG equipment. A 3G Gateway can operate either standalone or in tandem operation with a TANDBERG ...
Page 10 - The TANDBERG 3G Gateway
TANDBERG 3G Gateway User Manual 1.1 The TANDBERG 3G Gateway Front view The front panel provides 4 LAN interfaces, an LCD display, and an RS232 interface and control buttons. Rear view The back panel provides four PRI interfaces, which can be activated individually by software option keys, or 4 BRI i...
Page 11 - 3G GATEWAY Capacity – typical scenarios
TANDBERG 3G Gateway User Manual Blue Alarm indicates that the received frames are not synchronized properly. No LED’s light up, indicates that layer one framing is working (right protocol like for example EURO ISDN selected), however there is a problem at layer 2 caused by for example a CRC4 configu...
Page 12 - Installation
TANDBERG 3G Gateway User Manual 2 Installation Precautions: Never install telephone wiring during a lightning storm. Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations. Never touch uninstalled telephone wires or terminals unless the teleph...
Page 14 - Connecting cables
TANDBERG 3G Gateway User Manual 2.2 Connecting cables Power cable Connect the system power cable to an electrical distribution socket. ISDN PRI or BRI cables The E1/T1 cable should be connected to a CSU (Channel Service Unit). You will need a CSU between your 3G Gateway and the PRI line from your ne...
Page 15 - G Gateway Configuration
TANDBERG 3G Gateway User Manual 2.3 3G Gateway Configuration The 3G Gateway requires some basic configurations before it can be used. It will be necessary to find the IP-address and to create the dial-in and dial-out services program the ISDN-PRI Line numbers. It is possible to use the front panel L...
Page 18 - Using the 3G Gateway
TANDBERG 3G Gateway User Manual 3 Using the 3G Gateway 3.1 Call Overview The System Status windows of the Gateway can be accessed via the default URL: http://3G_Gateway_IP_Address/. The ‘ Overview ’ window presents information about all calls routed through the 3G Gateway, i.e. inbound and outbound ...
Page 24 - View System Status
TANDBERG 3G Gateway User Manual 4 View System Status To view current gateway status, open ‘System Status’ as shown in the figure below. 4.1.1 ISDN PRI/BRI Status PRI Status The colored part of the system status indicates the condition of the ISDN PRI line. There are three possible conditions: • Sync...
Page 27 - Status; Information
TANDBERG 3G Gateway User Manual 4.1.2 H.323 Status To view H.323 gatekeeper status, open ‘H.323 Status’ as shown in the figure below. Note that, since this target system is not an endpoint it is not possible to use this IP address to place calls to or through the 3G Gateway. IP Address Shows the IP ...
Page 28 - Resources
TANDBERG 3G Gateway User Manual 4.1.4 Available Resources To view available resources of the 3G Gateway, open ‘Available Resources’ of the System status tab, as shown in the figure below. This tab shows the actual System Load, the amount of video calls and the amount of available ISDN channels. Thes...
Page 29 - Configure the 3G Gateway; Configuration
TANDBERG 3G Gateway User Manual 5 Configure the 3G Gateway To configure the 3G Gateway, open ‘System Configuration’ tab, as shown in the figure below. In the system configuration window 9 tabs can be distinguished, i.e. PRI, SS7, IP, H.323, SIP, Video Portal, SNMP, Misc and Upgrade. The underlying s...
Page 30 - Interface Configuration; configuration
TANDBERG 3G Gateway User Manual Interface Configuration This section configures the PRI or ISDN interface. PRI CRC-4 Used for most E1-PRI configurations. If your network equipment does not support this feature, switch off PRI CRC-4. Bearer capabilities Within ISDN different bearer capabilities are u...
Page 32 - SS7 Configuration
TANDBERG 3G Gateway User Manual 5.2 SS7 Configuration To configure the Signaling System 7 (SS7 signaling) of the ISDN SS7 trunks click the ‘SS7’ link of the ‘System configuration’ tab, as depicted in the figure below. General • Originating Point Code (OPC). A number between 0-2 14 , which uniquely i...
Page 37 - IP Configuration Interface1
TANDBERG 3G Gateway User Manual 5.3 IP Configuration To configure the IP settings on the 3G Gateway, open ‘IP’ as shown in the figure below. IP Configuration Interface1 IP Address Assignment DHCP : Dynamic Host Configuration Protocol can be selected when a DHCP server is present. Static IP Address, ...
Page 39 - Gatekeeper Settings
TANDBERG 3G Gateway User Manual 5.4 H.323 Configuration To dial out from IP to ISDN, through the 3G Gateway, requires the use of H.323 numbers (E.164 aliases). This means that the 3G Gateway must be registered to a Gatekeeper. H.323 Gatekeeper Status shows the current status of the Gatekeeper regist...
Page 41 - SIP Configuration
TANDBERG 3G Gateway User Manual 5.5 SIP Configuration SIP settings Mode When set to “On” the 3G Gateway is registered to the SIP proxy. Proxy SIP proxy address Enter the IP Address of the proxy server the 3G Gateway should register to. SIP proxy port Enter the port number belonging to the above ment...
Page 42 - Video Portal Configuration
TANDBERG 3G Gateway User Manual 5.6 Video Portal Configuration Video Portal Settings Video Portal Mode When set to “Off” the 3G gateway will operate standalone. However, if it needs to be configured in tandem operation with a Video Portal the mode has to be set to “On”. Note that setting the Video P...
Page 43 - SNMP Configuration
TANDBERG 3G Gateway User Manual 5.7 SNMP Configuration SNMP (Simple Network Management Protocol) is used for monitoring and configuring different units in a network. The 3G Gateway’s SNMP Agent responds to requests from SNMP Managers (a PC program etc.). SNMP traps are generated by the agent to info...
Page 45 - Miscellaneous Configuration
TANDBERG 3G Gateway User Manual 5.8 Miscellaneous Configuration To configure the miscellaneous settings on the 3G Gateway, open ‘Misc’ as shown in the figure below. Configuration To change the system name of the 3G Gateway, enter the new system name in the ‘ System Name ’ field. Note that when the A...
Page 47 - Software Upgrade
TANDBERG 3G Gateway User Manual 5.9 Software Upgrade Software upgrade is where new software to the gateway can be installed from. It also shows current software version and the gateway’s hardware serial number. Note that to upgrade the 3G Gateway, a valid Release key and Software file is required. T...
Page 50 - Services Configuration
TANDBERG 3G Gateway User Manual 5.10 Services Configuration Dialing rules for both UMTS handsets, H.323 and SIP endpoints are configured via the services menu. In the services menu the following services types are distinguished: • “DiD” Æ Direct inward dialing H.323/SIP endpoint or 3G terminal. • “I...
Page 52 - all
TANDBERG 3G Gateway User Manual The numbers typed will appear after ca. 0.5 seconds on the screen. Pressing the # key after submitting the number triggers the 3G Gateway to make a connection with the respective endpoint. A separate phone number can be matched with an IVR phone book service. The figu...
Page 54 - Appendices
TANDBERG 3G Gateway User Manual 6 Appendices Appendix 1: Declaration of Conformity Appendix 2: Using the front panel LCD keys 54
Page 55 - Conformity
TANDBERG 3G Gateway User Manual 6.1 Appendix 1: Declaration of Conformity 55
Page 56 - LCD keys
TANDBERG 3G Gateway User Manual 6.2 Appendix 3: using the front panel LCD keys Every button on the front panel has multiple functions due to the limited amount of keys. In this appendix it is explained what the different functions are at different levels. State 0: Display Status info Any Key: State ...
Page 58 - Technical Specifications
TANDBERG 3G Gateway User Manual Technical Specifications MeanTime Between Failures: NSA1046: 37404 hr (flash base) . 58
Page 59 - Index
TANDBERG 3G Gateway User Manual Index A Accessing the gateway 16 Actions 19 Add new entry 29 Authentication 7, 43 Available Resources 34 B Bandwidth Option Key 49 Battery handling 3 Baudrate 45 BONDING 36 Border Controller 7, 28, 43 C Cables 14 Call Overview 17 Call Transfer 19 Capacity 61 Channel H...