Sunbeam SR5665 - Manuals

Using the shot of steam The shot of steam can be used when dry or steam ironing, when the temperature dial is set to any temperature within the steam band or above the two dot ( •• ) setting. 1. Ensure the tank is at least 1/4 full of water. 2. Select the desired temperature and wait until the boost...

After each use 1 Turn the STEAM/DRY dial to DRY.2 Turn the power off and remove the plug from the power outlet. 3 Empty any remaining water from the water tank. 4 Allow the iron to cool before winding the cord around the built-in cord wrap. Storage Always store the iron on its heel rest.NOTE: Do not...

Tip # 27 - Iron shirts like a pro Start with the collar, working from the outer edges into the middle. Iron the shoulder next, followed by the cuffs and sleeves. Place the collar at the narrow end of the board so that one front panel of the shirt is extended flat. Iron the front panel from shoulder ...

10 Ironing Chart FABRIC TEMPERATURE SETTING IRONING RECOMMENDATION Acrylic • Dry iron on wrong side. Acetate • Dry iron on wrong side while still damp or use spray to dampen. Nylon • Iron on wrong side while still damp or use spray to dampen. Polyester • Iron on wrong side while still damp or use sp...

Should you experience any difficulties with your appliance, please phone our customer service line for advice on 1300 881 861 in Australia, or 0800 786 232 in New Zealand. Alternatively, you can send a written claim to Sunbeam at the address listed below. On receipt of your claim, Sunbeam will seek ...