Sunbeam SR4300 - Manuals

Using your Sunbeam Pro Steam Iron Before first useRemove any adhesive stickers, plastic covers or cardboard sleeves from the soleplate. Ensure that all adhesive is removed by rubbing the soleplate with a cloth dampened with methylated spirits.Fill the water tank and empty the water. This will rinse ...

Using the shot of steamThe shot of steam can be used whether dry or steam ironing when the temperature dial is set to any temperature above the two dot (••) setting.1. Ensure the tank is at least ¼ full of water. 2. Select the desired temperature and wait until the thermostat light goes out. 3. Pres...

Care and Cleaning After each use1. Turn the power off and remove the plug from the power outlet. 2. Allow the iron to cool before winding the cord around the built-in cord wrap. StorageAlways store the iron on its heel rest.NOTE: Do not store the iron with the soleplate facing down, or in the carton...

Tip # 27 - Iron shirts like a proStart with the collar, working from the outer edges into the middle. Iron the shoulder next, followed by the cuffs and sleeves. Place the collar at the narrow end of the board so that one front panel of the shirt is extended flat. Iron the front panel from shoulder t...

Ironing Chart Fabric Temp setting Ironing Ironing recommendation Acrylic MINIMUM Min to • Dry iron on reverse side of fabric Acetate MINIMUM Min to • Dry iron on reverse side of fabric while still damp Nylon MINIMUM Min to • Iron on reverse side of fabric Polyester SYNTHETIC • Iron on reverse side o...

Should you experience any difficulties with your appliance, please phone our customer service line for advice on 1300 881 861 in Australia, or 0800 786 232 in New Zealand. Alternatively, you can send a written claim to Sunbeam at the address listed below. On receipt of your claim, Sunbeam will seek ...

Using your Sunbeam Pro Steam Iron Before first useRemove any adhesive stickers, plastic covers or cardboard sleeves from the soleplate. Ensure that all adhesive is removed by rubbing the soleplate with a cloth dampened with methylated spirits.Fill the water tank and empty the water. This will rinse ...

Using the shot of steamThe shot of steam can be used whether dry or steam ironing when the temperature dial is set to any temperature above the two dot (••) setting.1. Ensure the tank is at least ¼ full of water. 2. Select the desired temperature and wait until the thermostat light goes out. 3. Pres...

Care and Cleaning After each use1. Turn the power off and remove the plug from the power outlet. 2. Allow the iron to cool before winding the cord around the built-in cord wrap. StorageAlways store the iron on its heel rest.NOTE: Do not store the iron with the soleplate facing down, or in the carton...

Tip # 27 - Iron shirts like a proStart with the collar, working from the outer edges into the middle. Iron the shoulder next, followed by the cuffs and sleeves. Place the collar at the narrow end of the board so that one front panel of the shirt is extended flat. Iron the front panel from shoulder t...

Ironing Chart Fabric Temp setting Ironing Ironing recommendation Acrylic MINIMUM Min to • Dry iron on reverse side of fabric Acetate MINIMUM Min to • Dry iron on reverse side of fabric while still damp Nylon MINIMUM Min to • Iron on reverse side of fabric Polyester SYNTHETIC • Iron on reverse side o...

Should you experience any difficulties with your appliance, please phone our customer service line for advice on 1300 881 861 in Australia, or 0800 786 232 in New Zealand. Alternatively, you can send a written claim to Sunbeam at the address listed below. On receipt of your claim, Sunbeam will seek ...