Summit Appliance HL-630 OPC - Manuals

7 Goldstar GL-660 (Xerox W.C. Pro 610) 6R00833 Toner, 13R00532 OPC Toner: 5,000 pages, OPC: 10,000 Pages Toner With the Machine on, open the access cover. Press “MENU”, Press “6”, Press “3” Press “CLEAR”, Press “ENTER” OPC With the Machine on, open the access cover. Press “MENU”, Press “6”, Press “4...

9 HP Color LaserJet 3700 HP Black # Q2670A, Cyan Q2681A, Yellow Q2682A, Magenta Q2683A OEM Stated Toner Yield: 6000 Black, 6000 Color These cartridges have what HP now calls “Smart Chips” Similar to other HP chips, these chips monitor toner usage, Internet supplies ordering, and a new feature, remot...

10 HP Color LaserJet 4500 Transfer Belt HP OPC Part # C4196A OEM Stated Yield: 100,000 Black, 25,000 Color Press the menu button until “RESET MENU” is displayed. Press the “ITEM” button until “NEW TRANSFER KIT, SELECT IF DONE” is displayed. Press the “SELECT” button. Press the “ITEM” button until th...

13 set to YES on the cartridge chip. Even after the cartridge is refilled, the printer display will still show “Toner Low” for the supplies status section of the menu. Since these machines do not have a display, only the supplies status page will show “Non HP Toner cartridge”. If the chip is removed...

15 HP LaserJet 9000 HP Part # C4583X OEM Stated Yield: 30,000 Like the HP-4100, the 9000 cartridge also uses a chip. The chip in the 9000 is the same as the 4100 in that they only monitor usage not page counts. Each chip also has its own serial number which in effect gives the cartridge a serial num...

16 Kyocera F-3010 OPC Kyocera OPC Part # DK-2 OEM Stated Yield: 10,000 There is a small black fuse located on the board inside the cartridge. This fuse must be replaced each cycle by un-soldering the old and soldering in the new. This fuse is a special 250mA one that should be purchased from your su...

17 Lexmark 4023 (Optra W820/Xerox 4525) Lexmark Cartridge Part # 12B0090 OEM Stated Yield: 5840/5740: 10,000. 5845/5745: 25,000 The “Return” cartridges have an ARD on a small board located inside the right end cap of the cartridge. Unlike other Lexmark chips, the board for these cartridges has two c...

18 E-120 Drum cartridge: With the printer turned on, open the front door. Press and hold the CANCEL button until all the lights begin to cycle. Close the front door. Press the continue button to resume printing. Lexmark E220 Lexmark Cartridge Part 12S0300 (Return Program), 12S0400 (Standard) OEM Sta...

20 Lexmark E321/323 Lexmark Cartridge Part 12A7400/12A7405 (Prebate), 12A7305 (Non Prebate)) OEM Stated Yield: 3,000 (7400), 6000 (7305) The “Return” cartridges have an ARD on a small board located inside the right end cap of the cartridge. Like other cartridges in this series, the board for these c...

22 Lexmark W812 (Fuji-Xerox XP-26) Lexmark Cartridge Part # 14K0050 OEM Stated Yield: 12,000 These cartridges use a chip, but it is not the “Killer type” These chips monitor the “Toner Low” as well as tell the machine the brand of cartridge it is. So far we have seen Lexmark, Epson, and IBM machines...

23 Minolta PageWorks 1400 Minolta Toner cartridge Part #9J04203 Minolta Drum Cartridge Part # M4519401 OEM Stated Yield Toner: 2,000 OEM Stated Yield OPC: 20,000 Toner Cartridge: These toner cartridges have a chip that must be replaced each cycle. The chip is located on the bottom left side of the c...

26 Okidata OL-400e OPC Okidata OPC Cartridge Part # 56116801 OEM Stated Yield: 20,000 (The procedure for these machines is the same as used for the Okidata OL-1200, OP-20) Turn off the printer While holding the MENU1/MENU2 button down, turn the printer back on. Keep holding the button down until you...

28 Okidata OP-14e Okidata OPC Cartridge Part #41331601 (Type 8) OEM Stated Yield: 20,000 (The procedure for these machines is the same as used for the Okidata OP-6e, OL-600e, OP-10e) From the computer the printer is directly hooked up to, enter the Printer Status Monitor. Click on the “Printer Menu”...

30 will momentarily press in a lever inside the machine and start to reset the counter. The tape will then break releasing the lever finishing the reset procedure. Make sure you use a thin tape and not a packing tape, as it is important that the tape break fairly easily. Samsung CLP-300 Toner Cartri...

33 Samsung SCX-6320Toner/OPC Cartridges Samsung Cart. # SCX-6320D8 (Toner), SCX- 6320R2 (Drum) OEM Stated Yield: 8,000, 18,000 respectively Both of these cartridges use different items to reset the printer. The toner cartridge uses a chip that must be replaced/reset each cycle . There are different ...

34 pages. These cartridges are designed to be recycled by Sharp authorized dealers. As such, replacement chips are available from authorized Sharp dealers, and now generic chips are also available. Since the chip shuts down the cartridge at 10,000 pages, you can recycle the cartridge 2-3 times with ...

35 actuator (or flag) is next to the small gear). On some cartridges the "flag gear" is now black. It is located to the bottom right of the white gear. Make sure that when you snap the green end cap back on, the notch on the small gear lines up with the tab on the large single gear that is o...

36 Sharp AR-152 Developer Sharp Cartridge Part # AR-152DV OEM Stated Yield: 25,000 The developer is rated for 25,000 pages. The default setting on the machine is to keep running even after the 25K pages. That default setting can be set by the dealer to stop at 25K pages. It is considered a dealer op...

38 OEM Stated Yield: 20,000 (All) These cartridges do not use any reset procedures at all. According to the Sharp manual, they should be replaced when the copy quality deteriorates. No codes will show on the display to change the cartridge. NOTE: None of these cartridges are interchangeable, they al...

39 The display will read PCU DIAG MODE G. Press the MENU key repeatedly until you see COUNTER SET. Press the ENTER key once, and the MENU key twice. The display will read DRM 05000. Press and hold the DOWN ARROW key until the number resets to 00000. Press the MENU key four times, the Display will re...

40 Turn the power off. Hold down the exposure button, and turn the power on. All the lights except the ready light will come on. Release the exposure button. Press the exposure button again and hold for 10 seconds, until the three exposure lights come on. Release the exposure button. Once the ready ...

41 TEC LB-1305 OPC OEM Stated Yield: 10,000 (All) There are three major versions of these cartridges. Two use an external counter and one doesn't use one at all. The older style 1305 has no counter. The label on top of the cartridge has a place to write down the starting page count. You are supposed...

42 type of replacement cartridge that the machine is expecting. 001=113R180/181, 005 = 113R287. If the cartridges your machine needs is not available, you can change what type of cartridge the machine will accept by doing the following. Enter the diagnostics mode as in above. Enter “406 “ and press ...

43 cartridge is changed. A new fuse is not needed. However if the machine says change cartridge, the fuse is needed. Since you really have no way to know the state of your customer’s machine, we recommend that the fuse be replaced each cycle. These fuses are very inexpensive, and this way you have n...

44 use the correct connector. The 5012 will not work in the 5011 and vice-versa. To tell if you have the correct connector, read the resistance between pin’s 3 & 6. 5011 connectors read 15,000 ohms while 5012 connectors read 1,500 ohm Xerox 5012/5014 OPC 13R19 OEM Stated Yield: 18,000 The 5012 O...