Summit Appliance FF-7 - Manuals

Page 3 - Mounting Instructions

*Before Putting Into UsE* Before connecting the appliance to the power supply, leave it standing for about 2 hours, this will reduce the possibility of malfunctions in the cooling system due to transport handling. Clean the appliance thoroughly; especially in the interior (See Cleaning and Maintenan...

Page 4 - IMPORTANT; Disposing of the

IMPORTANT If you bought this appliance to replace an old one equipped with a lock that cannot be opened from inside (lock, bolt), make sure that the lock is broken. This will make it impossible for children to lock themselves inside the appliance and suffocate. The appliance must be correctly connec...

Page 5 - PLACING AND INSTALLATION; Spacers are manufactured for; Connection to Power Supply; “DO NOT USE AN EXTENSION CORD.”

PLACING AND INSTALLATION It is important to make sure the appliance is leveled evenly to prevent falling . Two spacers attached to the appliance must be fitted onto the upper edge of the condenser, thus preventing the appliance from being installed too close to the wall. Spacers are manufactured for...

Page 6 - Operation control; How To Adjust The Thermostat; To turn the refrigerator off you must turn the thermostat to 0 (off).

Operation control How To Adjust The Thermostat The refrigerator is controlled with a thermostat knob located inside unit, towards the right-hand corner. Turn the knob clockwise from the STOP (0) position toward higher numbers for colder temperatures. TEMPERATURE SELECTION The settings of the tempera...

Page 7 - Storing Fresh Foods; Never; store any inflammable, volatile or explosive substances.; automatic Defrosting

Storing Fresh Foods Foods to be stored in the refrigerator should be properly packed as to prevent mixing various moisture degrees and odors (in polyethylene bags or sheet, aluminum foil, wax paper, covered containers or bottles). Never store any inflammable, volatile or explosive substances. Bevera...

Page 8 - Cleaning the Appliance; Switch Off the Appliance When

There is no need to defrost the refrigerator, because the ice depositing on the inner back wall is defrosted automatically. Ice may deposit on the inner back wall during the compressor operation; later on when the compressor is not operating, the ice is defrosted and the water is collected and drain...

Page 9 - Door swing reversal

Door swing reversal ( Stainless steel models with towel bar handles do not have reversible doors.) If you find the direction of opening the door on your appliance inconvenient, you can change it. Holes on the opposite side have already been prepared at the factory 1. Remove the top hinge cover and h...

Page 10 - Adjusting the Level legs; BI; By turning the legs counter-clockwise; Trouble-Shooting Guide; Possible Cause/Solution

Adjusting the Level legs The Professional units (those with a BI suffix in model number) have 4 adjustable level legs. By turning the legs counter-clockwise you can increase the height of the unit up to 34” inches high or you may decrease the height to about 33” inches by turning clockwise. On Non-P...

Page 11 - Ice Formation on the Inner Rear Wall; Possible Causes; In case the ice formation on; Never use electric devices for defrosting and do not scrape; After defrosting is; Water is Leaking from the Refrigerator; Noise

Ice Formation on the Inner Rear Wall Possible Causes * The door does not seal well (clean the gasket if it is contaminated, or replace it if it is damaged). *The door was frequently opened or it was left opened for too long. *The food stored in the refrigerator was warm. Solution - As long as the de...

Page 12 - Specifications are Subject to Change Without

. After starting the appliance, the operation of the compressor and the refrigerant flow may be louder and this does not mean something is wrong with the appliance. The noise will reduce gradually. During the operation of the compressor, a liquid noise is heard and when the compressor is not operati...