Summit Appliance 42369 - Manuals

Page 2 - sides of the grill.; GENERAL CONSTRUCTION DETAILS; BUILT-IN CUTOUT DIMENSIONS

2 30 1/ 4 " Built-In Frame 34 1/ 4 " 24" min. 21" Access for electric on left hand side 6 1/4 " 3 3/ 4 " Gas Inlet Note: For a countertop treatment: Recommended 3/ 4 inch overhang. Notch front edge for frame to fully slide in. 6 1/ 4 " 3 3/ 4 " Gas Inlet 24" min. ...

Page 3 - PARTS LIST; OR

3 PARTS LIST Lid - 1 Cookbox - 1 Bottom Shelf - 1 Rear Panel Assembly - 1 Left Door - 1 Right Door - 1 Warming Rack - 1 Warm-Up ™ Rack - 1 Front Frame Rail - 1 Rear Frame Rail - 1 Right Enclosure Panel - 1 Left Enclosure Panel - 1 Front Vent Panel - 1 Lid - 1 Cookbox - 1 OR Rear Vent - 1 D4 D6

Page 5 - EXPLODED VIEW - PLATINUM D4; Platinum D4 LP Built-In

5 EXPLODED VIEW - PLATINUM D4 48 1 2 7740501 - Summit ® Platinum D4 LP Built-In 092005 17 18 19 21 38 39 40 6162 63 45 27 42 4 14 20 22 23 24 16 13 57 56 60 3 6 26 64 12 5 7 55 25 15 58 41 43 44 4647 49 50 51 10 9 8 525354 11 65 67 68 69 76 28 29 30 31 32 33 66 35 70 71 7374 36 59 72 75 37 34

Page 6 - EXPLODED VIEW - PLATINUM D6; Platinum D6 LP Built-In

6 EXPLODED VIEW - PLATINUM D6 8 50 1 2 7790501 - Summit ® Platinum D6 LP Built-In 092005 17 20 21 22 24 42 43 44 58 646566 67 68 47 30 52 9 10 13 12 45 4 6 7 16 23 26 27 28 29 53 55 18 14 15 51 56 60 59 62 57 3 48 49 54 46 19 11 5 25 61 70 71 72 77 78 31 32 33 34 37 38 39 69 40 73 74 7576 35 41 63 3...

Page 8 - ASSEMBLY

8 1 1 2 2 3 1 2 ATTENTION! Do not fully tighten screws. Clips should slide freely when installed. ASSEMBLY Arrow stickers on Frame Rail (1) and Left Side Panel (2) should point toward each other (shown above). Door Stop Bracket (3) should be positioned as shown (left).

Page 11 - CAUTION: Use two people to lift and install the Summit

11 ASSEMBLY CAUTION: Use two people to lift and install the Summit ® Built-In frame assembly. a.) Lift the frame assembly into the “island” structure opening. Make sure the frame is resting level on the fi nished surface of the structure. b.) Adjust the Front Vent to rest squarely on ground.c.) Appl...

Page 14 - Match Holder

Page 17 - TYPICAL BULK PROPANE GAS SUPPLY INSTALLATION; Caution: If young children are in the area, a; GAS SUPPLY; BUILT-IN GAS LINE LOCATIONS; Dimensions

17 6 1/ 4 " 3 3/ 4 " Gas Inlet B (6 1/ 4 ") A (3 3/ 4 ") C Side view Plan View Left Side Gas Inlet Table 10-1 Maximum Capacity of Pipe in Cubic Feet of Gas per Hour for Gas Pressures of 0.5 psi or Less and a Pressure Drop of 0.3 Inch Water Column. (Based on a 0.60 Specifi c Gravity G...

Page 18 - DANGER; TYPICAL 20 LP PROPANE GAS SUPPLY INSTALLATION

18 GAS LINE PIPING • Refer to the piping chart at the bottom of previous page. • The corrugated gas line from the manifold is 58 inches long. Do not extend the gas line. • We have provided the means to make an SAE 45° fl are connection. Do not use pipe sealant on this connection. • If the length of ...

Page 20 - VENTILATION; WARNING: Air holes must be provided in the structure; CONNECT GAS SUPPLY

20 VENTILATION WARNING: Air holes must be provided in the structure at the top and bottom to provide ventilation in the event of a gas leak. Air holes can be located in a low visibility area and should be protected by screening material to prevent rodents and insects from entering the structure. Air...