Summit Appliance 21287 - Manuals

Page 2 - WARNINGS

2 DANGERS & WARNINGS DANGER Failure to follow the Dangers, Warnings and Cautions contained in this Owner's Manual may result in serious bodily injury or death, or in a fi re or an explosion causing damage to property. WARNINGS Do not store a spare or disconnected liquid propane cylinder under or...

Page 3 - OPERATING; WARRANTY; Warranty

3 OPERATING WARNING: Only use the Weber ® Tank Enclosure Kit outdoors in a well-ventilated area. Do not use in a ga-rage, building, breezeway or any other enclosed area. WARNING: Your Weber ® Tank Enclosure Kit shall not be used under an unprotected combustible roof or over-hang. WARNING: Your Weber...

Page 4 - ASSEMBLY

4 Typical 20 LP propane gas supply Instal-lation We strongly recommend that you use the Summit ® Built-In Tank Cabinet (#21280) for installations using a 20 lb LP cyl-inder, mounted remotely in an “island” structure.The Summit ® Built-In Tank Cabinet is a CSA listed acces- sory for installing a remo...

Page 6 - PARTS LIST

6 4 8 4 1 2 4 2 2 PARTS LIST Hose and regulator - 1 Tank stand - 1 Tank stand base - 1 Tank Scale - 1 1/4-20 nut - 6 Nylon washer - 12 1/4-20 x 1/2" bolt - 6 Cylinder glide - 2 1/2" Flare Gasket - 2 3/8" Flare Gasket - 2 ASSEMBLY 2

Page 8 - GAS INSTRUCTIONS; CONNECT GAS SUPPLY; FILL LIQUID PROPANE CYLINDER

8 GAS INSTRUCTIONS 90ºfitting Connection to LP Tank Corrugated Gas Line to Manifold Cap (Optional Side Burner) Side View back of box top of box CONNECT GAS SUPPLY A 58" inch corrugated gas line is supplied with the grill. This line needs to pass through the gas inlet opening to the main gas supp...

Page 9 - WARNING: Do not use a wrench to tighten the con-; To Connect the hose to the cylinder:; CONNECTING THE LIQUID PROPANE CYLINDER; WARNING: Make sure that the LP cylinder valve is; DANGER

9 4) Screw the regulator coupling onto the tank valve, clock- wise, or to the right. Hand-tighten only. Note: This connection tightens clockwise and will not allow gas to fl ow unless the connection is tight. The connection requires tightening by hand only. WARNING: Do not use a wrench to tighten th...

Page 10 - CHECK FOR GAS LEAKS

10 Note - Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks.Make sure side burner is OFF.To perform leak checks: open cylinder valve by turning the cylinder valve hand-wheel counterclockwise. WARN...

Page 11 - REFILLING THE LIQUID PROPANE CYLINDER; Removal of the LP cylinder

11 REFILLING THE LIQUID PROPANE CYLINDER We recommend that you refi ll the LP cylinder before it is completely empty. Removal of the LP cylinder 1) Close cylinder valve (turn clockwise). 2) Unscrew regulator coupling by turning counterclockwise, by hand only. 3) Loosen cylinder lock wing nut and tur...

Page 12 - Burner does not light; Problem Check Cure; TANK CABINET TROUBLESHOOTING

12 Liquid Propane (LP) Cylinder(s) • The joint where the hose connects to the LP cylinder must be leak tested each time the LP cylinder is reconnected. For example, test each time the LP cylinder is refi lled. • Be sure the regulator is mounted with the small vent hole pointed downward so that it wi...