Page 3 - Table of Contents
i Table of Contents Hardware Guide ............................................................... 2 Package Contents ....................................................................... 2Front Panel .................................................................................. 2Rear Panel .....
Page 4 - Hardware Guide; Package Contents
2 Hardware Guide Package Contents 1 x Driver CD • 1 x Industrial Switch • 1 x Instruction Manual • 1 x Power Adapter • Front Panel Switch to Restore Default Settings - 1. This switch can be used to reset the product to its factory default settings. Pressing the switch using either a pen or similar t...
Page 6 - Hardware installation; Configuring the Adapter; Setting the IP Address
4 Hardware installation Use static electricity discharge precautions. Remove possible static 1. discharge potential from any objects that the adapter may come in contact with prior to installation. This can be accomplished by touching a bare metal chassis rail after you have turned off the power. If...
Page 8 - Managing the Adapter Settings
6 Setting the IP Address using the Em.exe Utility 3. The Em.exe is a Microsoft Windows based utility used to identify the adapters connected on the same subnet and network segment. To run the Em.exe utility, please insert the driver CD supplied with the Adapter. Open the program at the following loc...
Page 9 - Controller Setup Menu Items
7 Controller Setup Menu Items Menu Item Description IP Address 4 numbers separated by dots. If enabled, these can be assigned by the DHCP server. Subnet Mask 4 numbers separated by dots. If enabled, these can be assigned by the DHCP server. Gateway Address 4 numbers separated by dots. If enabled, th...
Page 11 - Software Installation; VSP Virtual COM Port Driver
9 Menu Item Description Packet mode inter- packet timeout In packet mode, the time constant used to determine if the packet is finished. Acceptable range is 10 to 1000 ms. Device ID User assigned device ID number. Acceptable range is 0 to 65535. Report device ID when connected If this function is en...
Page 12 - Installing the VSP Virtual COM Port Driver
10 Installing the VSP Virtual COM Port Driver Locate the necessary Software in the following folder on your driver 1. CD. The VSP COM.exe is the redirector software. The Em.exe is used to setup the hardware mode to support VSP redirector. Configure your hardware mode to support VSP. 2. Run the • EM....
Page 15 - Specifications
13 Specifications Specification NETRS2321POE LAN Connector RJ45 Speed 10/100Mbps RS-232 Number of Ports 1 x RS-232 Signals TXD, RXD, RTS, CTS, DTR, DSR, DCD, GND Connector DB9 Male (RS-232) Parity None, Odd, Even Data Bits 6, 7, 8 Stop Bits 1, 2 Speed 300 to 115.2Kbps Power Requirements Power Input ...