Spalding M85544C - Manuals - manualsarea.com

Page 2 - WARNING; SAFETY INSTRUCTIONS; REQUIRED TOOLS AND MATERIALS:

2 ID# M85544C 10/05 IMPORTANT! WRITE MODEL NUMBER FROM BOX ONTO PAGE 1 OF THIS OWNERS MANUAL Owner must ensure that all players know and follow these rules for safe operation of the system. WARNING • DO NOT HANG on the rim or any part of the system including backboard, support braces or net. • Durin...

Page 3 - PARTS LIST

3 10/05 ID# M85544C Item Qty. Part No. Description 1 1 968850 Pole 2 1 998850 Plate, Anchor, Black 3 1 Rim Assembly 4 1 Net 5 4 203017 Nut, Hex, 3/8-16 6 4 203300 Washer, Locking, 3/8 7 2 250001 Bolt, Hex, Tap, 3/8-16 x 4” Long 8 2* 250002 Bolt, Hex, Tap, 3/8-16 x 2” Long 9 1 203457 Label, Logo, Vin...

Page 4 - HARDWARE IDENTIFIER (OTHER—NOT ACTUAL SIZE)

4 ID# M85544C 10/05 Item #5 (4) Item #34 (4) Item #24 (9) Item #21 (16) Item #7 (2) Item #8 (2)* Item #28 (2)* Item #20 (1) Item #23 (2) Item #25 (12) Item #26 (1) HARDWARE IDENTIFIER (NUTS, WASHERS & SPACERS) Item #13 (2) Item #36 (1) Item #37 (1) Item #35 (1) Item #38 (14) Item #39 (4)Item #40...

Page 5 - Ensure ground is level with playing surface, then dig pole hole.

5 10/05 ID# M85544C Ensure ground is level with playing surface, then dig pole hole. Install threaded ends of J-bolts (19) through holesin mounting plate (2) and secure as shown. 2 25 25 25 19 19 Install nut (25) to J-bolt (19) asshown. Repeat procedure forremaining three J-bolts (19). 2.75” (7 cm) ...

Page 6 - SIDE VIEW; WAIT A MINIMUM OF 72 HOURS BEFORE GOING ON

6 ID# M85544C 10/05 Insert J-bolts (19) from mounting plate (2) into cement as shown. Move assembly around to releaseany air pockets in cement, then rest mounting plate on cement drainage hill. Apply some pressure tolevel mounting plate on top of drainage hill. Level mounting plate and square with p...

Page 9 - Completed Assembly; people are required to lift pole into; THIRD; While pole is being supported by; TWO; FIGURE

9 10/05 ID# M85544C THREE PEOPLEREQUIRED FOR THISPROCEDURE. FAILURETO FOLLOW THISWARNING COULD RESULTIN SERIOUS INJURYAND/OR PROPERTYDAMAGE. WARNING! 8. PL AY IN G SU RF AC E 26 24 35 37 36 14 Completed Assembly TWO people are required to lift pole into position so that the threaded assemblyrod (14)...

Page 14 - Rim Assembly

14 ID# M85544C 10/05 13. 5 8 Refer To Instructions Included With Rim Hardware For Rim Assembly. 3 Rim Assembly 6 10 7 IMPORTANT! Carefully cut and peelprotective film away fromboard prior to attaching rim. Before starting rim assembly, tighten nut (26) until it is positioned 6-3/4” fromthe end of th...

Page 15 - Set-up For Right Side

15 10/05 ID# M85544C 14. A. B. 15. Apply height indicatorlabels (32 & 31) to heightindicators (30). Attach height indicators to lower yoke in area shown by turning screws(29) into place with a phillips-head screwdriver. Apply name platesticker (15) to lower yoke as shown. 2. 4. 3. 1. Install net...

Page 19 - What is Not Covered By This Warranty; RIM; LIMITED LIFETIME WARRANTY

19 10/05 ID# M85544C Subject to proper installation and normal use, Hydra-Rib ® warrants, subject to limitations below, to the original retail purchaser all structural components of the Hydra-Rib ® system to be free of defects in material and workmanship for the duration of ownership by the original...