Page 2 - WARNING
2 P/N 214994B 05/03 WARNING FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE. Owner must ensure that all players know and follow these rules for safe operation of the system. • DO NOT HANG on the rim or any part of the system including backboard, support braces or...
Page 3 - SAFETY INSTRUCTIONS; Use caution when using this system.; MOVING SYSTEM; HEIGHT ADJUSTMENT
05/03 P/N 214994B 3 SAFETY INSTRUCTIONS FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN SERIOUS INJURY OR PROPERTY DAMAGE AND WILL VOID WARRANTY. Owner must ensure that all players know and follow these rules for safe operation of the system. To ensure safety, do not attempt to assemble th...
Page 4 - or
4 P/N 214994B 05/03 For more information on assembly, placement, properuse and maintenance, visit The American BasketballCouncil website at http://www.smarthoops.com. IMPORTANT! Remove all contents from boxes. Be sure to check inside pole sections; hardware and additional parts are packed inside. NO...
Page 5 - FRONT
05/03 P/N 214994B 5 Get to know the basic parts of your basketball system..... STRUTS BACKBOARD FRONT RIM WHEEL CARRIAGE ASSEMBLY BASE POLE
Page 6 - Description
6 P/N 214994B 05/03 PARTS LIST - (See Hardware Identifier) Item Qty. Part No. Description 1 1 206645 Tank (Black) 2 1 200628 Wheel Axle 3 2 226401 Wheel 4 1 900060 Top Pole Section 5 1 908480 Middle Pole Section with Label 6 1 908490 Bottom Pole Section 7 1 202820 Rod, 3/8 O.D. x 4-3/4 Long 8 1 2028...
Page 7 - HARDWARE IDENTIFIER
05/03 P/N 214994B 7 HARDWARE IDENTIFIER Item #14 (1) Item #12 (6) Item #10 (1) Item #19 (12) Item #16 (2) Item #17 (6) Item #21 (4) Item #28 (2) Item #22 (4) Item #23 (2) Item #8 (1) Item #11 (1) Item #7 (1)
Page 8 - ASSEMBLE THE BASE
8 P/N 214994B 05/03 TOOLS REQUIRED FOR THIS SECTION HARDWARE USED IN THIS SECTION (not actual size) SECTION A: ASSEMBLE THE BASE 9/16” and 1/2” 9/16” and 1/2” AND/OR This is what your system will look likewhen you’ve finished this section: Item #14 (1) Item #12 (6) Item #10 (1) Item #16 (2) Item #17...
Page 9 - TOP
05/03 P/N 214994B 9 1. 1 Remove contents from tank 5” (13 cm) 2. Correctly identify each polesection and mark indicateddistance from ends with tape(not supplied) as shown. 3. IMPORTANT! Center the alignment slot of middle pole section (5) in thelower hole of top pole section (4) as shown. While main...
Page 10 - While maintaining alignment, bounce
10 P/N 214994B 05/03 4 5 6 WOOD SCRAP 4. IMPORTANT! Center the alignment slot of lower pole section (6) in the lowerhole of middle pole section (4) as shown. While maintaining alignment, bounce top and middle pole assembly (4 & 5) onto bottom section of pole (6) using woodscrap as shown until th...
Page 13 - ASSEMBLE THE BOARD AND RIM
05/03 P/N 214994B 13 TOOLS REQUIRED FOR THIS SECTION HARDWARE USED IN THIS SECTION (not actual size) SECTION B: ASSEMBLE THE BOARD AND RIM 1/2” 1/2” AND/OR This is what your system will look likewhen you’ve finished this section: Item #19 (12) Item #17 (6) Item #21 (4) Item #22 (4) Item #23 (2)
Page 14 - Final adjustments will be made in Step 3 of this section; Refer To
14 P/N 214994B 05/03 21 22 22 18 20 17 17 Mount brackets (20) and rim (18) to backboard and finger tighten as shown. NOTE: Final adjustments will be made in Step 3 of this section IMPORTANT! For spring loaded rim assembly, refer to instructionsincluded with rim hardware. 1. Refer To Instructions Inc...
Page 15 - DO NOT LEAVE
05/03 P/N 214994B 15 2. SAWHORSE OR SUPPORT TABLE 5 24 23 3. While still in the horizontal position, carefully slide backboard componentsonto pole. Secure hardware at desired position as shown and tighten allhardware completely at this time. Support pole and tank assembly over support table. Careful...
Page 16 - Push second “arm” back and into ram as shown.
16 P/N 214994B 05/03 4. Install clips. CLIP “ARM” CLIP “BODY” Insert one “arm” of clip into ram as shown. Twist “body” of clipslightly so that second “arm” slides over the top of the first “arm”as shown.Push in direction indicated by arrows. Push second “arm” back and into ram as shown. Twist “body”...
Page 17 - Insert net into bottom of clip as shown.; NET INSTALLATION
05/03 P/N 214994B 17 Insert net into bottom of clip as shown. SIDE VIEW Twist net until it snaps into position.Net must be centered through clip. NET NETCLIP SIDE VIEW NET NETCLIP NET INSTALLATION 9. 18 19 25
Page 18 - APPLY HEIGHT AND MOVING LABEL & SECURING SYSTEM
18 P/N 214994B 05/03 15 1. 10 feet (3.05 m) Carefully upright assembly. Apply moving system label (15) to front of pole asshown. Regulation rim height is 10 feet (3.05 m). TWO PEOPLEREQUIRED FOR THISPROCEDURE. FAILURETO FOLLOW THISWARNING COULDRESULT IN SERIOUSINJURY AND/ORPROPERTY DAMAGE. WARNING! ...
Page 19 - CONSIGNES DE SÉCURITÉ; Equipement de basketball port; VIS AUX
05/03 P/N 214994B 19 Numéro d’appel gratuit du service après-vente. Etats-Unis et Canada uniquement: 1-800-284-8339 Numéro vert international (France, Suisse) : 00 800 555 85234 TUFF STUFF® et les marques associées de Mattel, Inc. sont utilisées avec sa permission. Les produits Huffy ne sont nulleme...
Page 21 - ADVERTENCIA; INSTRUCCIONES DE SEGURIDAD; ESCRIBA SU NÚMERO DE MODELO:; Manual del propiet; VISO P
05/03 P/N 214994B 21 00 800 555 85234 SI NO SE OBSERVAN ESTAS ADVERTENCIAS SE PUEDEN OCASIONAR LESIONES GRAVES Y/O DAÑOS MATERIALES El propietario debe asegurarse de que todos los jugadores onozcan y sigan estas reglas para la operación segura del istema . • NO SE CUELGUE del borde ni de ninguna par...
Page 23 - SICHERHEITSHINWEISE; ARNUNG; ragbares Basketball-System Benutzerhandbuch; Huffy steht zur Qualität seiner Produkte!; HINWEIS A
05/03 P/N 214994B 23 Universelle gebührenfreie Telefonnummer (Deutschland, Schweiz): 00 800 555 85234 SICHERHEITSHINWEISE Die meisten Verletzungen werden durch einen unvorschriftsmäßigen Gebrauch und/oder ein Mißachten der Sicherheitshinweise verursacht. Beim Gebrauch dieser Vorrichtung Vorsicht wal...