Sony Ericsson GTR-64 - Manuals

Page 2 - GTR64; Important information; We cannot accept any responsibility for consequential loss.; Service and Support; To contact customer support please use the contact details below:

GTR64 http://www.matrix.es/GTR64 Important information This technical description contains important information for start up and use of the GTR64 Terminal. Read it carefully before you start working with the GTR64 Terminal. The warranty will be void should damage occur due to non-compliance with th...

Page 6 - Digital Input/Output; General Features

GTR64 http://www.matrix.es/GTR64 1.2 Highlights Radio Features Quad Band GSM/GPRS GSM 850/900 Power class 4 (33dBm) GSM 1800/1900 Power class 1 (30dBm) Mobile Class B Extended Measurement Reporting Compliant with 3GPP Release 99 Protocol Stack Interfaces RS232 9–way Dsub Expansion Port: 15-way HD-Ds...

Page 7 - Multiple UART access; GTR-64 Wireless modems in a Communication System

GTR64 http://www.matrix.es/GTR64 Voice Features Telephony Emergency calls Full Rate, Enhanced Full Rate, Half Rate and Adaptive Multi-rate (FR/EFR/HR/AMR) Noise suppression and echo cancellation Sidetone/microphone amplification Short Message Service (SMS) Features Text and PDU Point to point (MT/MO...

Page 8 - Preliminary. Subject to change without prior notice

GTR64 http://www.matrix.es/GTR64 Figure 1. Main Blocks in a Wireless System (external micro-controller) Figure 2. Main Blocks in a Wireless System (embedded application) GTR64 Integrators Manual V.1.2 Pag. 8 Preliminary. Subject to change without prior notice

Page 9 - Main Features and Services

GTR64 http://www.matrix.es/GTR64 1.4 Main Features and Services The GTR64 performs a set of telecom services (TS) according to GSM standard phase 2+, ETSI and ITU- T. The services and functions of the GTR64 are implemented by issuing customised applications embedded on the device, or by AT commands ...

Page 11 - MECHANICAL DESCRIPTION

GTR64 http://www.matrix.es/GTR64 2. MECHANICAL DESCRIPTION 2.1 Overview The pictures below show the mechanical design of the module along with the positions of the different connectors and mounting holes. The module case is made of durable PC/ABS plastic. Figure 3. GTR64 Module viewed from the right...

Page 13 - ELECTRICAL DESCRIPTION; Dir

GTR64 http://www.matrix.es/GTR64 3. ELECTRICAL DESCRIPTION All electrical connections to the module are protected in compliance with the standard air and contact Electrostatic Discharge (ESD). The module uses the following industry standard connectors: • Sub-D 9 pin female (Main RS232 serial port) •...

Page 15 - ni USB Connector

GTR64 http://www.matrix.es/GTR64 The ele cteristics are gi able belo ctrical chara ven in the t w. Parameter Conditions Min Typ Max Unit R 1.34 1.5 1. L = 30 Ω 68 Vrms R 1.41 Vrms le RL = 8 Ω 1.24 Vrms Hz or GR64 users to configure various modes of operation. Each profile is e. The customer can modi...

Page 17 - Pin Signal Dir Voltage

GTR64 http://www.matrix.es/GTR64 3.6 RS232 Serial Port he modem supports a standard RS232 serial interface (EIA/TIA 574) via its 9 pin Sub-D connector, own below. In line with serial communication terminology the GTR64 serial modem should be nsidered as the data circuit-terminating equipment (DCE) a...

Page 18 - Serial Data From Mo

GTR64 http://www.matrix.es/GTR64 3.6.1 Serial Data The modem su ts t er • 1 start bit, 7 or 8 data bits, 1 optiona it, 1 or 2 stop bits • Programmable baud rate • Auto-configur n m ith to-b ut In line with ser om atio rm e ta circuit-terminating equipment (DCE) and the external application or comput...

Page 19 - ICE

GTR64 http://www.matrix.es/GTR64 Data Carrier Detect (DCD) DCD indicates that the DCE is receiving a valid carrier (data signal) when low. You can define the exact behaviour of DCD with an AT command. Ring Indicator (RI) RI indicates that a ringing signal is being received by the DCE when low. You c...

Page 23 - unconnected; Switching On the Modem

GTR64 http://www.matrix.es/GTR64 SERVICE Input Flash programming enable signal The SERVICE input signal is for flash programming enable input. The SERVICE pin is driven active high by the host application using either a logic control input or applying a dc voltage (common in legacy applications) to ...

Page 24 - . EMBEDDED APPLICATIONS; ation

GTR64 http://www.matrix.es/GTR64 Operating State LED Status After switching on the modem On after 4s Switch off (Power down) or power removed Off Standby or talk Flashing No network, network search, no SIM card, no PIN entered On Notes! Switch off (Power Down): DC power is applied but the modem is s...

Page 25 - power; SAFETY AND PRODUCT CARE; Modem”, before starting your integration work!

GTR64 http://www.matrix.es/GTR64 Code cannot be ported directly from an existing application and loaded directly onto the radio device. It must be re written in the Sony Ericsson Mobile script language so that the ra dio device interpreter can function 5.2.2 M IDE (Integrated Developers Environment)...

Page 27 - . INSTALLATION OF THE MODEM; Where to install the modem

GTR64 http://www.matrix.es/GTR64 IEEE (The Institute of Electrical and Electronics Engineers Inc.), through periodic and thorough evaluation of scientific studies. These guidelines establish permitted levels of radio wave exposure for the general opulation. The levels include a safety margin designe...

Page 28 - s to GTR64 Terminal; .2 How to install the modem

GTR64 http://www.matrix.es/GTR64 Tip! Before installing the modem, use an ordinary mobile telephone to check a possible location for it. s to GTR64 Terminal instance, improperly made connections or or quipment. .1.4 Network and Subscription .2 How to install the modem it is powered from a battery or...

Page 31 - Patch Adeshive Antenna; Patch Antenna; Right angle short antenna

GTR64 http://www.matrix.es/GTR64 D) Patch Adeshive Antenna OPANIEL TECHNOLOGIES http://www.opaniel.com MTX-UT902 – FME F 118.003.024 MTX- UT-902, RG174 3 mts, GSM DUAL BAND ( 900 / 1800 MHz ) A Patch Antenna Cable RG174 3 Meters Gain 2 dB Frequency: 824-960 MHz, NTENNA 1770-1880mhZ C) Right angle sh...