SEAGATE ST36540A - Manuals

Non-ATA compatible slave jumper If your computer does not recognize your new drive as a master in atwo-drive system, the slave drive may not be ATA-compatible. You maybe able to solve this problem by installing jumpers on pins 5 and 6 andon pins 7 and 8, as shown in the illustration below. Cable Sel...

other peripheral cards, one at a time, until the conflict reccurs. After youhave isolated the source of the address conflict, you can resolve theconflict by changing the I/O address of the peripheral that appears tocause the conflict. • If Disk Manager has installed the DDO on your hard drive and yo...

p g y , , Windows 95, Windows NT 3.51, Window NT 3.50 (requires DM upgradedrivers), OS/2 V3.0 (Warp full pack), and OS/2 V2.0–3.0 (requires DMupgrade drivers). Before you install a non-DOS operating system on the drive, install DOSand Disk Manager and make sure that the drive is bootable. Instructio...

p y ! Caution. If you change the drive-type values in thesystem setup program, you must partition andformat the drive again. This erases data on the drive. • If you have partitioned the drive into individual logical drives, you mayneed to make the partitions smaller to access the full drive capacity...