SEAGATE ST2000DX001 - Manuals

Desktop SSHD Product Manual, Rev. B 7 For information regarding online support and services, visit http://www.seagate.com/about/contact-us/technical- support/ Available services include: • Presales & Technical support • Global Support Services telephone numbers & business hours • Authorized ...

Desktop SSHD Product Manual, Rev. B 9 1.0 Introduction This manual describes the functional, mechanical and interface specifications for the following Seagate ® Desktop SSHD model drives: These drives provide the following key features: • 8GB NAND flash • 5900 and 7200 RPM spindle speed • High insta...

Desktop SSHD Product Manual, Rev. B 11 2.0 Drive Specifications Unless otherwise noted, all specifications are measured under ambient conditions, at 25°C, and nominal power. For convenience, the phrases the drive and this drive are used throughout this manual to indicate the following drive models: ...

12 Desktop SSHD Product Manual, Rev. B Drive Specifications www.seagate.com *All specifications above are based on native configurations. ** One GB equals one billion bytes and 1TB equals one trillion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating en...

Desktop SSHD Product Manual, Rev. B 13 www.seagate.com Drive Specifications 2.2 Formatted capacity *One GB equals one billion bytes and 1TB equals one trillion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting. 2.2.1 LBA mode ...

14 Desktop SSHD Product Manual, Rev. B Drive Specifications www.seagate.com 2.4 Recording and interface technology 2.5 Physical characteristics Interface SATA Recording method TGMR Recording density (kFCI) 1807 Track density (ktracks/inch avg) 1TB and 2TB 352 4TB 340 Areal density (Gb/in 2 ) 625 Spi...

Desktop SSHD Product Manual, Rev. B 15 www.seagate.com Drive Specifications 2.6 Seek time Seek measurements are taken with nominal power at 25°C ambient temperature. All times are measured using drive diagnostics. The specifications in the table below are defined as follows: • Track-to-track seek ti...

16 Desktop SSHD Product Manual, Rev. B Drive Specifications www.seagate.com • Idle mode power Idle mode power is measured with the drive up to speed, with servo electronics active and with the heads in arandom track location. • Standby mode During Standby mode, the drive accepts commands, but the dr...

Desktop SSHD Product Manual, Rev. B 17 www.seagate.com Drive Specifications 2.8.2 Conducted noise Input noise ripple is measured at the host system power supply across an equivalent 80-ohm resistive load on the +12 volt line or an equivalent 15-ohm resistive load on the +5 volt line. • Using 12-volt...

18 Desktop SSHD Product Manual, Rev. B Drive Specifications www.seagate.com activity is required, the drive makes a transition to Standby mode. In both Idle and Standby mode, the driveaccepts all commands and returns to Active mode when disk access is necessary. 2.9 Environmental specifications This...

20 Desktop SSHD Product Manual, Rev. B Drive Specifications www.seagate.com to operational levels . 2.10.1 Test for Prominent Discrete Tones (PDTs) Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this process is the use of the absolute threshold of h...

Desktop SSHD Product Manual, Rev. B 21 www.seagate.com Drive Specifications Drives are tested in representative end-user systems. Although CE-marked Seagate drives comply with the directives when used in the test systems, we cannot guarantee that all systems will comply with the directives. The driv...

22 Desktop SSHD Product Manual, Rev. B Drive Specifications www.seagate.com 2.14.1 European Union Restriction of Hazardous Substances (RoHS) Directive The European Union Restriction of Hazardous Substances (RoHS) Directive, restricts the presence of chemical substances, including Lead, Cadmium, Merc...

Desktop SSHD Product Manual, Rev. B 23 3.0 Configuring and Mounting the Drive This section contains the specifications and instructions for configuring and mounting the drive. 3.1 Handling and static-discharge precautions After unpacking, and before installation, the drive may be exposed to potentia...

24 Desktop SSHD Product Manual, Rev. B Configuring and Mounting the Drive www.seagate.com Figure 2 Attaching SATA cabling Each cable is keyed to ensure correct orientation. Desktop SSHD drives support latching SATA connectors. 3.4 Drive mounting You can mount the drive in any orientation using four ...

Desktop SSHD Product Manual, Rev. B 27 4.0 SATA Interface These drives use the industry-standard Serial ATA (SATA) interface that supports FIS data transfers. It supports ATA programmed input/output (PIO) modes 0 to 4; multiword DMA modes 0 to 2, and Ultra DMA modes 0 to 6. For detailed information ...

28 Desktop SSHD Product Manual, Rev. B SATA Interface www.seagate.com Notes 1. All pins are in a single row, with a 1.27 mm (0.050 in) pitch. 2. The comments on the mating sequence apply to the case of backplane blindmate connector only. In this case, the mating sequences are: • the ground pins P4 a...

Desktop SSHD Product Manual, Rev. B 29 www.seagate.com SATA Interface Download Microcode 92 H Execute Device Diagnostics 90 H Flush Cache E7 H Flush Cache Extended EA H Format Track 50 H Identify Device EC H Idle E3 H Idle Immediate E1 H Initialize Device Parameters 91 H Read Buffer E4 H Read DMA C8...

Desktop SSHD Product Manual, Rev. B 31 www.seagate.com SATA Interface 4.3.1 Identify Device command The Identify Device command (command code EC H ) transfers information about the drive to the host following power up. The data is organized as a single 512-byte block of data, whose contents are show...

Desktop SSHD Product Manual, Rev. B 33 www.seagate.com SATA Interface 92 Master password revision code FFFE H 93 Hardware reset value xxxx H 94 Automatic acoustic management 8080 H 95–99 ATA-reserved 0000 H 100–103 Total number of user-addressable LBA sectors available (see Section 2.2 for related i...

36 Desktop SSHD Product Manual, Rev. B SATA Interface www.seagate.com 4.3.3 S.M.A.R.T. commands S.M.A.R.T. provides near-term failure prediction for disk drives. When S.M.A.R.T. is enabled, the drive monitors predetermined drive attributes that are susceptible to degradation over time. If self-monit...

Desktop SSHD Product Manual, Rev B 37 A ACA 21acceleration 19acoustics 19Active 17Active mode 17Agency certification 20altitude 18Ambient temperature 18ambient temperature 15areal density 14ATA commands 28Australia/New Zealand Standard AS/NZ CISPR22 21Australian Communication Authority (ACA) 21Austr...

38 Desktop SSHD Product Manual, Rev B N noise 17nominal power 15Nonoperating shock 19Nonoperating vibration 19 O operating 16Operating power 15Operating shock 18Operating vibration 19 P Physical characteristics 14point-to-point 9, 23Power consumption 15power dissipation 16Power modes 17Power specifi...

Seagate Technology LLC AMERICAS Seagate Technology LLC 10200 South De Anza Boulevard, Cupertino, California 95014, United States, 408-658-1000ASIA/PACIFIC Seagate Singapore International Headquarters Pte. Ltd. 7000 Ang Mo Kio Avenue 5, Singapore 569877, 65-6485-3888EUROPE, MIDDLE EAST AND AFRICA Sea...