SEAGATE ST3390N - Manual
SEAGATE ST3390N – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 4 – Sicherheitsanleitung; Configuring the drive; Setting the SCSI ID. Each device on the bus must have a
- Page 6 – Installing jumpers on the active/passive termination; using Fast SCSI transfer rates, or; Fast SCSI; Active
- Page 7 – Attaching cables; Connecting a remote LED. Remote LED pins are located on; User-configuration jumper block: pins 9 and 10; Attaching the power cable. Attach a system power cable to; the drive power connector.
- Page 10 – Mounting the drive; Caution. If you use a screw that is too long, you could damage
- Page 11 – Figure 3. Recommended mounting orientations
- Page 12 – CMOS setup for AT systems; Note. If you are installing your drive in an AT system and a hard; no hard drive installed option.
- Page 13 – Caution. If you format a drive at any level, you erase all your; Partitioning; Caution. If you partition or format a drive at any level, you erase; High-level formatting
- Page 14 – To high-level format the drive, perform the following operations:; Use the FORMAT utility to high-level format the drive. Refer; to your DOS manual for the FORMAT command options.; If you are formatting the boot drive, copy the necessary system; Troubleshooting; Warning. Always turn off the system before changing jumpers or; unplugging cables and cards.
- Page 17 – The screen stays blank when you power up the system.; Make sure the monitor is plugged in and turned on.
- Page 18 – Technical support services
. . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . .
ST3390N, ST3655N
. . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . .
SCSI Interface Drive
. . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . .
Installation Guide
. . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . .
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Radio and television interference. This product complies withClass B limits for radio noise emissions from computer equipmentas set out in the radio interference regulations of the CanadianDepartment of Communications. Le présent appareil numérique n ′ émet pas de bruits radioélectriques depassant l...
4. Installing jumpers on the active/passive termination jumper block. If you removed the terminating resistors fromthe drive according to the instructions in step 2, skip this step. If you are either: • using Fast SCSI transfer rates, or • not using Fast SCSI transfer rates, and both ends of the I/O...
Attaching cables Refer to Figure 1 on page 6 and Figure 2 on page 7 for thelocations of the connectors and jumper blocks. 1. Turn off the system power. 2. Put on a grounded wrist strap. 3. Connecting a remote LED. Remote LED pins are located on two separate jumper blocks: the options jumper block an...
