SEAGATE KSD-541-P - Manuals

Page 4 - Table of Contents

- 4 - Table of Contents 1. Introduction .................................................................................................. 5 1.1 Features ................................................................................................................... 6 1.2 Product Panels ............

Page 9 - Mounting the Switch on a Wall

- 9 - 2. Installation 2.1 Unpacking The product package contains: • The switch unit • One product CD-ROM 2.2 Safety Cautions To reduce the risk of bodily injury, electrical shock, fire, and damage to the product, observe thefollowing precautions. • Do not service any product except as explained in y...

Page 11 - Install the bracket on the bottom of the switch unit.

-11- 2.5 Panel Mounting One panel mounting bracket is provided in the product package as shown below: Install the bracket on the bottom of the switch unit. The final dimension after panel bracket is installed is shown below: 2.6 Applying Power The switch provides two types of power interfaces, termi...

Page 12 - Using Terminal Blocks; Three terminal contacts are provided:; Using DC Power Jack; PoE applications

-12- Using Terminal Blocks Three terminal contacts are provided: Vdc Positive ( + ) terminal Vdc Negative ( - ) terminal Chassis ground * Working Vdc for general application: +6V ~ +60VDC* Working Vdc for PoE application : +43V ~ +54VDC (Typ. 48V) One 3P terminal plugs are provided together with the...

Page 13 - Making Connections; Making UTP Connections; Network Cables; Making Fiber Connection; transceiver. Hold the bail and make insertion.; Connecting Fiber Cables

-13- 3. Making Connections 3.1 Making UTP Connections The copper ports support the following connection types and distances: Network Cables 10BASE-T: 2-pair UTP Cat. 3,4,5 , EIA/TIA-568B 100-ohm 100BASE-TX: 2-pair / 4-pair UTP Cat. 5, EIA/TIA-568B 100-ohmLink distance: Up to 100 meters Auto MDI/MDI-...

Page 14 - Making PoE Connections; DC IN power = Sum of all connected PD power required + 3 watts; The PSE ports are equipped with the following capabilities:

-14- 3.3 Making PoE Connections This section describes how to make a connection between a PSE port and a PoE PD device. For thePoE switch model, Port 2, Port 3, Port 4 and Port 5 are equipped with PoE PSE function. The portsare enabled to deliver power together with network signal to a connected pow...

Page 16 - Applications with Basic Switch Model

-16- 4. Applications 4.1 Applications with Basic Switch Model The following figure illustrates a basic switch model connects five computers via Cat.5 cables. The following figure illustrates a basic switch model connects four computers via Cat.5 cables anduplink to a fiber backbone network.

Page 17 - Applications with PoE Switch Model

-17- 4.2 Applications with PoE Switch Model The figure below illustrates a PoE switch connects four PoE IP cameras via Cat.5 cables and uplinks toa fiber backbone: The figure below illustrates a PoE switch connects four PoE WLAN access points via Cat.5 cables anduplinks to a backbone: