Roland CUBE-60 - Manuals - manualsarea.com

Page 2 - IMPORTANT SAFETY INSTRUCTIONS

2 30 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION : RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symb...

Page 4 - NOTICE; FEDERAL COMMUNICATIONS COMMISSION

4 015 • Do not force the unit’s power-supply cord to share an outlet with an unreasonable number of other devices. Be especially careful when using extension cords—the total power used by all devices you have connected to the extension cord’s outlet must never exceed the power rating (watts/amperes)...

Page 5 - IMPORTANT NOTES; Power Supply

5 IMPORTANT NOTES 291b In addition to the items listed under “IMPORTANT SAFETY INSTRUCTIONS” and “USING THE UNIT SAFELY” on pages 2, 3 and 4, please read and observe the following: Power Supply 301 • Do not connect this unit to same electrical outlet that is being used by an electrical appliance tha...

Page 6 - Panel Descriptions; Control Panel; JC CLEAN Channel; LEAD Channel

6 Panel Descriptions Control Panel fig.01 1. INPUT Jack Connect your guitar here. 2. SELECT Switch Switches you between the JC CLEAN and LEAD channels. You can confirm which channel is selected by checking the indicator’s color (JC CLEAN: green; LEAD: red).The channel can be switched using the optio...

Page 7 - EQUALIZER

7 Panel Descriptions * All product names mentioned in this document are trademarks or registered trademarks of their respective owners, and are not related to Roland Corporation.In this manual, these names are used as appropriate ways to indicate sounds that are simulated using COSM technology. 6. G...

Page 8 - Rear Panel

8 Panel Descriptions Rear Panel 1. FOOT SW (Foot Switch) Jack Foot switches (the optional BOSS FS-5U) are connected here. * Set the polarity switch as shown below. fig.06 (CH SELECT) Switches JC CLEAN/LEAD channels. (EFX) Switches on and off of EFX. (DELAY/REVERB) Switches on and off of DELAY/REVERB...

Page 9 - Sample Settings; Alternative Metal; Space Clean; Swamp Crunch; Classic Rock

9 Sample Settings Alternative Metal The perfect sound for heavy, sharp riffs. Select the high-gain R-FIER amp, then use the equalizer to boost the low end even more. You can add even more to the distortion’s edge by raising the presence. Used with a humbucking pickup in the rear position, it results...

Page 10 - Dynamic Style

10 Sample Settings Dynamic Style DYNA AMP is an original amp that uses relative picking strength to create changes in distortion depth. First, adjust the GAIN knob so that a clean tone is obtained with soft picking and deep distortion is obtained when you pick hard.Now, mixing arpeggios played with ...

Page 11 - Main Specifications; Block Diagram

11 Main Specifications Rated Power Output 60 W Nominal Input Level (1 kHz) INPUT: -10 dBu/1 M Ω Speaker 30 cm (12 inches) Controls POWER Switch, SELECT Switch <JC CLEAN Channel> BRIGHT Switch, VOLUME Knob <LEAD Channel> TYPE Switch (ACOUSTIC, BLACK PANEL, BRIT COMBO, TWEED, CLASSIC STACK...

Page 12 - Information

SD000453 1GT Information When you need repair service, call your nearest Roland Service Center or authorized Roland distributor in your country as shown below. As of November 1, 2003 (Roland) ARGENTINA Instrumentos Musicales S.A. Av.Santa Fe 2055 (1123) Buenos AiresARGENTINATEL: (011) 4508-2700 BRAZ...