Rheem RXIH-AS09A- Manuals

Humidification System 3 69-2307—01 WhaT you WIll need To InsTall The humIdIsTaT Tools/Hardware needed: • Wire stripper/cutter• Drill or duct-cutting tool• 1-3/4-in. hole saw• 1/8-in. drill bit• Phillips and slotted (or Torx) screwdriver• 18-gauge thermostat wire (5 or 2 conductor) Material Provided:...

Installation Guide 69-2307—01 4 safeTy PReCauTIons CAUTION: Voltage Hazard. Can cause electrical shock or equipment damage. Disconnect HVAC equipment before beginning installation. Safety Precautions • Do not direct the steam nozzle at people.• If used near a pool or spa, ensure the humidifier can n...

Humidification System 5 69-2307—01 safeTy PReCauTIons M24744 duCT mounT InsTallaTIon Choose a location that has access to a: • Drain allowing a slope of 1/4 in. per foot of drain hose. • Cold water line.• Electrical circuit rated to your humidifier. • Vertical surface with adequate clearances. 1 Mod...

Installation Guide 69-2307—01 6 duCT mounT InsTallaTIon A) Slide foam gasket over nozzle and insert the nozzle into duct hole (pictured). B) Push down to secure humidifier to bracket arms. Ensure gasket forms tight seal in duct hole. Secure bracket to duct using #8 self-drilling sheet metal screws (...

Humidification System 7 69-2307—01 M24896A Funnel or floor drain. Refer to governing codes for drain pipe size and maximum temperature requirements. 6 in. 8 in. Most operation problems are caused by improper hose installation. Always ensure an uphill flow when installing the remote hose, and avoid k...

Installation Guide 69-2307—01 8 Note: If air handler location temperatures will drop below freezing at any time, the humidifier must be mounted in a conditioned space, running a remote hose to the duct. M24786 Living Area Remote Options M24781 Furnace or Mechanical Room Remote M24785 Garage Remote M...

Humidification System 9 69-2307—01 2 IN. PER FT 2 IN. PER FT 2 IN. PER FT 2 IN. PER FT 20 FT MAX P - TRAP DRAIN WITH TRAP 5 FT MAX 3 FT MAXIMU M DRAIN P - TRAP IF NO SLOPE 10 FT MAX GENTLE BEND OBSTRUCTION SUPPORTED REMOTE HOSE 20 FT MAX DRAIN WETTED P - TRAP NOTE: HEIGHT OF TRAP MUST BE GREATER THA...

Installation Guide 69-2307—01 10 RemoTe mounT InsTallaTIon M24744 M24745 M24764 Install hose adapter from Remote Mount Kit. 2 Model Minimum Circuit Capacity RXIH-AS06A 7 Amps RXIH-AS09A 10 Amps RXIH-AS12A 12 Amps Continuous downflow M24765 Remote Mount Kit (sold separately) Hose Adapter Duct Nozzle ...

Humidification System 11 69-2307—01 M24766 Position template sticker on remote location. Note: The humidifier will weigh 12–15 lbs. (+/- 2 lbs.) with water, so if mounting onto drywall or plaster, position one side over a wall stud. 3 4 Insert wall anchors (4) into pilot holes and secure bracket to ...

Humidification System 13 69-2307—01 RemoTe mounT InsTallaTIon RemoTe mounT InsTallaTIon To install clamps onto the insulated steam hose: Cut a slit in the insulation half way around the house. Do not cut into the steam hose. Insert the hose clamp into the slit and hook it onto the hose. A B A B

Installation Guide 69-2307—01 14 M24852 M24772 PlumbIng A Insert 1/4-in. water line into filter. Apply modest pressure to ensure a tight fit. 10 B Insert 1/4-in. water line into back-flow valve. Apply modest pressure for a tight fit. Water line tapping options. See instructions provided with the opt...

Humidification System 15 69-2307—01 Loosen captive cover screw. Slide cover out from front. 11 M24754 WIRIng CAUTION: Voltage Hazard. Before wiring to HVAC terminals, disconnect HVAC equipment power. Ensure humidifier is not plugged in. Low-Voltage Terminals 24V AC power for electronic humidistat. H...

Installation Guide 69-2307—01 16 WIRIng 12 Wire the humidifier according to the diagram that applies to your humidity control. Follow this diagram if using a mechanical humidistat. HVAC RECOMMENDED AIR FLOW SWITCH (AFS) MECHANICAL HUMIDISTAT HVAC POWER MASTER THERMOSTAT HUM HUM G Y W R Rc G Y W R C ...

Humidification System 17 69-2307—01 Slide the cover back into place and secure captive screw. Turn on the water supply and plug in the humidifier. 13 The Press Reset light will blink when power is applied. Press/release the RESET button to ready the humidifier. If not pushed, the humidifier will aut...

Installation Guide 69-2307—01 18 dIP sWITCh seleCTIon Between the transformer and LED display on the circuit board are two sets of DIP switches. DIP 1 and 2 can be configured to adjust cleaning cycles. DIP 4 and 5 can simplify wiring. DIP 3 and 6 are not used at this time. Details below. M24853 OFF ...

Humidification System 19 69-2307—01 The humidifier has internal system diagnostics that monitor system operation, maintenance sched- ules, and faults. If a system fault is detected, the system will attempt to recover itself up to five times in a 24 hour period. If unable to recover in that time, the...

Installation Guide 69-2307—01 22 sPeCIfICaTIons Capacity: RXIH-AS12A: 12 gallons per day (gpd) (45 liters per day [lpd]) RXIH-AS09A: 9 gpd (34 lpd) RXIH-AS06A: 6 gpd (23 lpd) Humidified Area: House Description Air Changes Per Hour RXIH- AS12A RXIH- AS09A RXIH- AS06A Loose Two 2000 ft 2 1300 ft 2 100...

Humidification System 23 69-2307—01 Maintenance is simple with the humidistat—just remove the water tank for cleaning. EMPTY M24774 CLEAN TANK (BLINKING LIGHT) M24775 M24776 CLEAN TANK (ON SOLID) Warning: Scalding hazard. Do not attempt to remove the humidifier from the mounting bracket during opera...

Humidification System 25 69-2307—01 7. Replace inline filter once per year. Turn water supply off before replacing. Press down filter collar ring and pull out 1/4 in. water line from each side. Insert 1/4 in. lines into new filter. Apply modest pressure to ensure a tight fit. M27410 M27411 Once clea...

® U.S. Registered Trademark.© 200869-2307—01 M.S. 12-08 Printed in U.S.A. on recycled paper containing at least 10% post-consumer paper fibers. 5 years from date of purchase (contact the Rheem Parts Distribution Center for more information). Warranty Information “In keeping with its policy of contin...