Remington 476 - Manuals

7 Safety Precautions ? ? ? ? CENTERPUNCH TEST Sinks inwithaveragehammerblow TOO SOFT TOO HARD Pointflattens Surfaceshatters Start 3 GREEN 2 BROWN 4 YELLOW CAST IRON GLASS TILE BRICK 1 GRAY TOO BRITTLE G 018 G 018 G 018 G 018 G 018 G 018

9 Safety Precautions 1” TOO THIN WELD 1/2” NO YES G 018 G 018 G 018 G 018 76 mm 3" 3X 1X 76mm 3" 76mm 3" 76mm 3" 5 mm MIN3/16" 25 mm 1" 13 mm 1/2"

10 OPERATING THE TOOL 1. ALWAYS hold tool perpendicular towork surface. 2. Should the tool fail to fire, hold themuzzle firmly against the work sur-face for 30 seconds. Then removethe tool, eject the load and safelydiscard the misfired load into wateror oil. 3. ALWAYS use the spall shield whendrivin...

11 ;; ;; ;; GAS LINE GASOLINE 482-49 POWDER LOADS 482-51 POW DER LOADS Safety Precautions ;; ;; ;; 90 ° ;; ;; ;; ; ; ; ; ; ; 30 ;; ;; ;; WATER SpallShield G 018 G 018 G 018 G 018 G 018

15 Safety Precautions Overdriven Fasteners An overdriven fastener results when toostrong of a powder load is used causingthe piston to extend past the muzzle.Move to the next lightest powder load.Repeated overdrive will damage yourtool. By avoiding overdrive, you can ex-tend the life of your tool co...

16 LOADING THE POWERHAMMER1. Insert the proper fastener into themuzzle, round metal head first.Push fastener until the point is evenwith the end of the muzzle. 2. Grab the muzzle and pull forwarduntil it stops. This sets the pistonand opens the chamber area. 3. Insert the proper Remington Pow-der Lo...

17 Operation SpringMust BeCompressed FiringPin Line Up Grooves Muzzle FiringPin Grip Barrel Chamber LOADING FIRING EJECTING Continued

18 CARE OF YOUR POWERHAMMERClean your Powerhammer after eachday’s use. Clean chamber with acces-sory wire brush, part number 56485.Apply good quality penetrating lubricantspray (such as WD-40) sparingly andwipe dry. NOTE: The labor regulations of manycounties require that the operator of thistool on...

19 Limited Warranty DESA International warrants this RemingtonModel 476 POWERHAMMER against defects inmaterials and workmanship for a period of 30days from the date of purchase. This warrantyextends only to the original purchaser of thePOWERHAMMER and only applies if thePOWERHAMMER is used for norma...

101915-01Rev. B8/96 IMPORTANT This tool is designed to useRemington 22 caliber neck-downcrimped loads, power levels 1(gray) through 4 (yellow). Straight Wadded Power Load Neck-Down Crimped Power Load NOTICE: This is your Owner’s Manual. Read Carefully before operating your Remington POWERHAMMER Acce...