RELIABLE 140IS - Manuals

06 RECOMMENDATIONS DO’S 1. Check that the main voltage stated on the rating plate corresponds to the local electricity supply. 2. Unwind and straighten the power cord and supply cord before use. 3. Place the appliance on a firm and steady surface. 4. The iron must be used and rested on a stable surf...

07 CAUTION DONT’S 1. Do not allow children to touch the appliance when ironing. 2. Do not leave the appliance unattended when it is connected to a main supply outlet. 3. Do not use an extension power cord set unless it corresponds with your local manu-facturing standards. 4. Do not add perfume, vine...

09 1. Steam Trigger 7. Anti-scale Cartridge 2. Soleplate 8. Control Panel 3. Iron Unit 9. Base Unit 4. Carry Lock 5. Water Inlet Cover 6. Water Tank MAVEN 140IS KEY FEATURES 1 3 2 4 7 5 6 8 9

FILLING THE WATER TANK 1. Disconnect the power cord from the electric outlet. 2. Pull out the water tank (Figure 2). 3. Open the water inlet cover and fill tank with water until the maximum level(Figure 3). 4. Put the water tank back and make sure that it is firmly positioned in place(Figure 4). CAR...

PROGRAMMED TEMPERATURE Auto Mode The appliance is equipped with a programmed temperature feature which allows it to iron all ironable fabrics without adjusting the temperature of the iron. It is the default mode of this appliance. The ECO indicator will light up when the lowest temperature is being ...

TEMPERATURE CONTROL SETTINGS Acetate Elastane Polyamide Polyester Silk Viscose Wool Cotton Linen If you are not sure about the fabric is made of, use the auto mode or start ironing at a low temperature. AUTO STEAM FUNCTION The appliance will automatically adjust the steam output to the selected temp...

VERTICAL STEAMING You can remove wrinkles from garments, curtains and fabrics in hanging positions. 1. Select your desired steam temperaturesetting. 2. Hold the iron in a vertical position (Figure 7)15 to 30 centimeters away from the garment. 3. Press the steam trigger. Warning: Do not apply steam t...

DRAINING THE WATER TANK Disconnect the iron from the main supply outlet 1. Pull out the water tank (Figure 9). 2. Open the Water Inlet Cover and drain the water tank (Figure 10). 3. Put the water tank back and make sure that it is firmly positioned in place(Figure 11) FIGURE 9 FIGURE 10 FIGURE 11 AN...

FIGURE 16 1. When the self-clean indicator lights up with a beep, itindicates that the appliance needs to undergo a self-cleaning (Figure 17). 2. Fill the water tank to the max level (See ‘FILLING THEWATER TANK’) and plug in the appliance. 3. Press the function (temp) button followed by the steamtri...

CLEANING AND MAINTENANCE 1. Disconnect the power cord from the main power supply. 2. Use a damp cloth to remove deposits from the soleplate and exterior parts ofthe iron. 3. Never use sharp or rough objects to remove deposits from the sole plate. STORAGE 1. Make sure the water is completely drained ...

TROUBLESHOOTING If your steam station does not work well, check the following points: PROBLEM CAUSE SOLUTION The unit does not work There is not enough heat Wait for unit to heat up It is not plugged in Plug unit in The anti-scale cartridge is not installed/installed improperly Install the scale car...