RadioShack PLCDCS 200 - Manuals

Page 2 - CONTENTS

2 Installation .....................................................................................................3 Wiring Connection ........................................................................................4 4 x 50W System ..............................................................

Page 3 - INSTALLATION; Method A

3 INSTALLATION Method A Method B SUB PANEL FLANGE NUT 2#BRACKET MOUNTING SCREW DASH PANEL MOUNTING SCREW QUICKIE BOLT SUB PANEL FLANGE NUT QUICKIE BOLT REAR BUSHING FACTORY BRACKET MOUNTING SCREW DASH PANEL QUICKIE BOLT STANDARD MOUNTING CONFIGURATION 2#BRACKET 1#BRACKET “JA” MOUNTING CONFIGURATION ...

Page 4 - WIRING CONNECTION

4 For 4 x 50W System WIRING CONNECTION GREEN GREEN/BLACK GREY GREY/BLACK VIOLET VIOLET/BLACK MAIN UNIT WHITE WHITE/BLACK FRONT Lch SPEAKER REAR Lch SPEAKER FRONT RchSPEAKER REAR RchSPEAKER Rch RED Lch WHITE (GREY) RCA CABLE Rch RED Lch WHITE (BLACK) TV AUDIO IN ANTENNA SOCKET RED BLUE POWER ANTENNA ...

Page 5 - OPERATION

5 OPERATION 5 28 25 26 24 4 18 27 23 22 21 20 19 11 14 13 17 16 9 12 10 7 1 6 2 15 3 8

Page 6 - GENERAL OPERATION

6 GENERAL OPERATION Note: In this product design, there has different sound accompanying with everybutton pressed and the sound isdesigned differently according to thecustomers. • ON/OFF Switch on the unit by pressing POWER button (9). When system is on, press POWER button (9) again to turn off the ...

Page 8 - FUNCTION KEYS & CONTROL

8 OPERATION FUNCTION KEYS & CONTROL 1. PWR = Power Button 2. MUT = Mute Button 3. SEL = Select Button 4. VOL = Volume Up Button 5. VOL = Volume Down Button 6. BND = Band Select Button 7. MOD = Mode Button 8. TUNE/SEEK = Tune/Seek Down Button 9. TUNE/SEEK = Tune/Seek Up Button 10. EQ = Preset Equ...

Page 9 - SPECIFICATIONS

9 GENERAL P ower Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 200 mm (W) x 138 mm (D) x 75 mm (H) Loading Impedance : 4 - 8 Ω per channel Maximum Output P ower : 4 x 50 Watts Current Drain : 10 Ampere (max.) CD PLA YER Signal to Noise Ratio : More than 55 dB Channel Separa...

Page 10 - TROUBLE SHOOTING

10 Before going through the check list, check wiring connection. If any of the problemspersist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power. The car ignition switch is If the power supply is properly not on. connected to the car accessorycircui...

Page 11 - MAINTENANCE; For System

11 MAINTENANCE For System The following suggestions help you carefor the product so that you can enjoy itfor years. 1. Keep the product dry. If it does get wet, wipe it dry immediately.Liquids might contain minerals that can corrode the electronic circuits. 2. Keep the product away from dust and dir...

Page 12 - CAUTION; IGNITION AND INTERFERENCE NOISE; Interference

CAUTION 1. This unit is designed to operate on 12-volts DC, negative ground electrical system only. Do not attemptto install this unit in a vehicle having apositive ground system. 2. You should not touch the high-polished playback head with anymetallic or magnetic tools. 3. Your unit has built-in fi...