Page 2 - INSTALLATION; driving function of the driver.
2 INSTALLATION Notes: • Choose the mounting location where the unit will not interfere with the normal driving function of the driver. • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. • Use o...
Page 4 - HOW TO REMOVE AND INSTALL THE FRONT PANEL; Keep front panel into the case.; REMOVING THE FRONT PANEL
4 HOW TO REMOVE AND INSTALL THE FRONT PANEL 1. Press the release button and pull-off the front panel. Keep front panel into the case. 2. To install the front panel, insert the panel into the housing and make sure the panel is properly installed, otherwise, abnormalities occurs on the display or some...
Page 5 - WIRING CONNECTION; unconnected and isolated.
5 WIRING CONNECTION Note:1. For 2-speakers system, green, violet, white/black and grey/black wire leads are unconnected and isolated. 2. For 2-speakers system, keep the fader indicator at center position to maintain the existing volume level. WHITE WHITE/BLACK GREEN GREEN/BLACK Lch SPK. WHITE GREEN/...
Page 6 - OPERATION; GENERAL OPERATION; Switch on the unit by pressing any button [except button (4) and; button; • FACEPLATE RELEASE; Press; RELEASE
6 OPERATION GENERAL OPERATION • ON/OFF Switch on the unit by pressing any button [except button (4) and RELEASE button (7)]. When system is on, press button (9) to turn off the unit. • FACEPLATE RELEASE Press RELEASE button (7) to detach the removable faceplate. 24 25 14 8 23 15 6 19 9 22 21 20 13 7...
Page 8 - RADIO OPERATION
8 RADIO OPERATION • BAND SELECTION At tuner mode, press BND/LOU button (13) shortly to select the desired band. The reception band will change in the following order: • STATION SELECTION Press TUNE/SEEK/TRACK button (16) or TUNE/SEEK/TRACK button (17) shortly to activate automatic seek function. Pre...
Page 9 - CD OPERATION
9 CD OPERATION • SELECT TRACKS Press TUNE/SEEK/TRACK button (16) or TUNE/SEEK/TRACK button (17) to move to the previous track or the following track. Track number shows on display.Hold TUNE/SEEK/TRACK button (16) or TUNE/SEEK/TRACK button (17) to fast reverse or fast forward. CD play starts from whe...
Page 10 - SPECIFICATION; GENERAL; FM
10 SPECIFICATION GENERAL P ower Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 178 (W) x 165 (D) x 50 (H) Tone Controls- Bass (at 100 Hz) : + 10 dB / – 10 dB - Treble (at 10 KHz) : + 10 dB / – 10 dB Maximum Output P ower : 40W x 4 (ch) Current Drain : 5 Ampere (max.) CD PLA ...
Page 11 - TROUBLE SHOOTING; Symptom
11 TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problemspersist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power. The car ignition switch is If the power supply is properly not on. connected to the ca...