RadioShack ET-910 - Manuals

5 CONTENTS Installation ...................................................................................................... 7 Selecting a Location .................................................................................... 7Placing the Base on a Desktop .....................................

7 INSTALLATION SELECTING A LOCATION You can set the ET-910’s base on aflat surface (such as a desktop orcounter-top), mount it on a modularjack wall plate, or mount it directly onthe wall. The base’s location affectsthe phone’s range. If you have achoice of several locations, try eachto see which on...

8 MOUNTING THE BASE ON A WALL Using the supplied mounting bracket,you can mount the ET-910’s base ona phone jack wall plate or directly onthe wall. To prepare the bracket for mounting,twist off the tabs attached to the cen-ter of the bracket and press them se-curely into the holes on the narrowend o...

12 PREPARATION INSTALLING THE BATTERY PACK To install the supplied rechargeablebattery pack, place it on the batterycompartment tracks, then slide it up(toward the antenna) until it locks inplace. Note: You must charge a new batterypack at least 24 hours before you useit the first time. When the han...

13 Notes: • If the CHARGE indicator does not light or blinks continuouslywhen you place the handset onthe cradle, be sure the batteryand AC adapter are correctlyand securely connected. Also,check the charging contacts onboth the handset and base. Ifthe contacts are dirty or tar-nished, clean them wi...

15 2. Within 30 seconds, press # , then press 1 - 4 (one key after the other) to hear the different ringertypes. The ET-910 sounds a dif-ferent ringer type for each key. Notes: • To hear the currently selected ringer type, press 0 anytime after you press # during this step. • If the indicator above ...

16 OPERATION Important: If you move the handsetoutside the base’s range, the hand-set will not operate properly and acall in progress might be disconnect-ed (see “Troubleshooting” onPage 26). Note: You can use the keypad on ei-ther the handset or the base to oper-ate the ET-910. To use the phone’sfe...

17 • To turn the handset’s volume up or down during a call, press or on the side of the handset. To end a call, place the handset onthe base or press OFF . The HAND- SET IN USE indicator on the baseand the TALK indicator on the hand-set turn off. Using the Speakerphone To make a call using the speak...

18 Switching Between the Handset and Speakerphone To switch to the speakerphone at anytime during a call while you are usingthe handset, simply press SPKR on the base so its red indicator turns on,then press OFF to turn off the hand- set. To switch to the handset at any timeduring a call while you a...

19 USING HOLD To place a call on hold, simply press HOLD . The HOLD indicator on the base and the TALK indicator on thehandset (if it is off the base) flash toremind you that the call is on hold.You and the other party cannot heareach other. To take a call off hold and resumeyour conversation, simpl...

21 SPECIAL FEATURES USING MEMORY DIALING You can store up to 10 numbers inthe ET-910’s memory, then dial themat the press of a few buttons. Notes: • Each phone number can be up to 16 digits long. • You can use either the base or the handset to program and dialstored numbers on the ET-910. Storing a ...

22 To store additional numbers, repeatSteps 1-4 for each number you wantto store. Notes: • To change a number in memory, simply store a new one in itsplace. • To erase a number from mem- ory, repeat Steps 1-4, and skipStep 3. • Write the memory location num- ber and name associated witheach stored p...

23 Chain Dialing Service Numbers You can make a call using more thanone of the ET-910’s memory loca-tions. This is called chain dialing.Chain dialing is useful for dialing spe-cial services such as alternate longdistance or bank-by-phone. When calling special services, dialthe service’s main number ...

24 Paging from the Base to the Handset To send a page from the base to thehandset, press and release INT.CM on the base. The handset soundsfive distinctive rings (different thanthe ringer type for a normal call), andthe base’s INT.CM indicator lightssteadily during each ring. To answer a page at the...

25 USING HANDSET/BASE DISABLE To disable the other keypad (the oneyou are not using) at any time duringa call so no one can use that keypadto access your call or an outgoingline, simply press PROG on the key- pad you are currently using. Notes: • Pressing PROG on your keypad does not disable other t...

26 TROUBLESHOOTING We do not expect you to have any problems with your phone, but if you do, thefollowing suggestions might help. Problem Solution Low volume or unusual sounds. • Someone has picked up at another phone on the same line. Hang up the other phone. • Press on the handset to turn up the h...

28 If you still have problems, disconnect the phone. If other phones on the same linework properly, the fault is in this phone or its installation. If you cannot find theproblem, take your phone to your local Radio Shack store for assistance. Problem Solution The caller’s voice gets cut off and is h...

29 OUT OF RANGE INDICATIONS If you move the ET-910’s handset outof the base’s range, the handset willnot operate properly. While it is out ofrange, the handset sounds differentalert tones and flashes various indi-cators. Note: To turn off the out of range in-dications while the handset is out ofrang...

30 CARE AND MAINTENANCE Your Radio Shack ET-910 900 MHz Digital Cordless Speakerphone With DualKeypads is an example of superior design and craftsmanship. The following sug-gestions will help you care for your phone so you can enjoy it for years. Keep the phone dry. If it gets wet, wipe it dry immed...

31 THE FCC WANTS YOU TO KNOW In the unlikely event that your phonecauses problems on the phone line,the phone company can temporarilydiscontinue your service. The phonecompany normally attempts to notifyyou in advance. If advance notice isnot practical, the phone company no-tifies you as soon as pos...

RADIO SHACK A Division of Tandy Corporation Fort Worth, Texas 76102 3A7 Printed in Hong Kong Limited One-Year Warranty This product is warranted by RadioShack against manufacturing defects in material and workman-ship under normal use for one (1) year from the date of purchase from RadioShack compan...