RadioShack ET-148 - Manuals

Page 2 - FEATURES; Its features include:

2 FEATURES Your RadioShack ET-148 20-NumberMemory Speakerphone with Privacy isdesigned to exacting standards that en-sure reliability, long life, and outstandingperformance. Its features include: 20-Number Memory Dialing — letsyou store up to 15 digits in each of 20memory locations for easy dialing....

Page 3 - ringer equivalence number; FCC STATEMENT; This telephone complies with Part 68 of; FCC Rules; • coin-operated systems

3 This symbol is intended to alert you tothe presence of uninsulated danger-ous voltage within the product’s enclo-sure that might be of sufficientmagnitude to constitute a risk of elec-tric shock. Do not open the product’scase. This symbol is intended to inform youthat important operating and maint...

Page 4 - CONTENTS

4 CONTENTS Preparation .............................................................................................................. 5 Installing Batteries .............................................................................................. 5 Testing/Replacing the Batteries .................

Page 5 - PREPARATION; INSTALLING BATTERIES; Testing/Replacing the Batteries

5 PREPARATION INSTALLING BATTERIES Your telephone uses two AAA batteries(not supplied) for power to retain thenumbers you store in memory. For thebest performance and longest life, werecommend alkaline batteries, such asCat. No. 23-555. Cautions: • Always use fresh batteries of the required size and...

Page 6 - SELECTING A LOCATION; only; Mounting the Phone on a Wall

6 To prevent the loss of stored numberswhen the batteries are removed, replacethe batteries within 5 minutes. Set NORM/STORE BATT TEST back to NORM . SELECTING A LOCATION You can place the phone on a desk topor table, or mount it on a telephone wallplate or directly on the wall. Select a lo-cation t...

Page 10 - OPERATION; USING PRIVACY

10 OPERATION Make and receive calls with this phoneas you would with any other phone. Thissection describes some of the phone’sspecial features. USING THE SPEAKERPHONE To make or receive a call on the speak-erphone, leave the handset in the cradleand press SPEAKER . Slide VOLUME on the right side of...

Page 12 - MEMORY DIALING; Storing a Number in Memory

12 MEMORY DIALING You can store up to 20 numbers inmemory (15 digits each in the tonemode, 16 in the pulse mode), then dial astored number by pressing a memorybutton. Note: Entering a pause counts as onedigit in memory. Storing a Number in Memory Note: Leave the handset in its cradlewhen storing a n...

Page 13 - • If the telephone rings while you are; • If you make a mistake while storing; to; then reset it to; Dialing a Memory Number

13 Notes: • If the telephone rings while you are storing numbers, you can answerthe call by lifting the handset orpressing SPEAKER . If you answer a call before pressing the memorybutton for the number you were stor-ing, you must start again from Step3 after the phone call. • If you make a mistake w...

Page 14 - TROUBLESHOOTING; Problem; Be sure; Ensure the phone line is properly connected.

14 TROUBLESHOOTING We do not expect you to have any problems with your phone, but if you do, the follow-ing suggestions might help. If you still have problems, disconnect the phone. If other phones on the same line workproperly, the fault is in this phone or its installation. If you cannot find the ...

Page 15 - CARE AND MAINTENANCE; minerals that corrode electronic circuits.; THE FCC WANTS YOU TO KNOW

15 CARE AND MAINTENANCE Your RadioShack ET-148 20-Number Memory Speakerphone with Privacy is an ex-ample of superior design and craftsmanship. The following suggestions will help youcare for your phone so you can enjoy it for years. • Keep the phone dry. If it gets wet, wipe it dry immediately. Liqu...

Page 16 - LIGHTNING

RadioShack A Division of Tandy Corporation Fort Worth, Texas 76102 811081170B 1A8 Printed in China LIGHTNING Your telephone has built-in protection circuits to reduce the risk of damage from surg-es in telephone line and power line current. These protection circuits meet or exceedthe FCC requirement...