RadioShack and Speakerphone - Manuals

8 Features ˆ Features Your RadioShack Digital 900 MHz Dual Key-pad Cordless Speakerphone operates on the900 MHz band, which means less interfer-ence, clearer sound, and greater range than46/49 MHz cordless telephones. The CallerID records each caller's telephone number(and name, if available in your...

9 Installation ˆ Installation Note: The base's display is protected duringshipment by a piece of film. Carefully peel offthis film before using your phone for the firsttime. MOUNTING THE PHONE You can place the phone's base on a desk ortable, mount it on a standard wall plate, ormount it directly on...

10 Installation 5. Route the adapter’s cord through the strain relief slot on the bottom of thebracket. 6. Plug the adapter into a standard AC out- let. 7. Lift the base’s antenna to a vertical posi- tion. On a Wall Plate or Wall 1. Insert the bracket’s tabs into the base’s lower tab slots, then pre...

14 Operation ˆ Operation Note: To use the speakerphone, you mustuse the base keypad; to use the handset,you must use the handset keypad. MAKING A CALL Using the Handset To make a call, lift the handset and press TALK . JWba JWba JWba JWba and current volume setting appear on the handset's display. &...

15 Operation an error beep. Move closer to the base andtry again. USING MUTE To talk to someone in the room while usingthe speakerphone without the person on theother end of the phone line hearing your con-versation, press MUTE/DELETE on the base. Ckj[ Ckj[ Ckj[ Ckj[ appears on the base's display. P...

17 Operation press SPEAKER . The call is released from hold and transferred to the handset and thedisplay changes to >WdZi[j >WdZi[j >WdZi[j >WdZi[j _d _d_d _d Ki[ Ki[ Ki[ Ki[ . To bring the base back into the conversation for athree-way conference, press SPEAKER again. OUT OF RANGE If y...

19 Operation Storing a Number in the Base Follow these steps to store numbers in thebase: 1. Hold down MEMORY until Ijeh[ Ijeh[ Ijeh[ Ijeh[ DkcX[h DkcX[h DkcX[h DkcX[h appears on the base's display. 2. Enter the phone number and any tone or pause entries (see “Entering a Pause”). If you make a mista...

20 Operation Reviewing Memory Numbers Handset To review your memory numbers stored inthe handset, press MEM . The list of memory location numbers ( &' &' &' &' – (& (& (& (& ) and the name stored with each number (or ý 2C[cehodd4 ý 2C[cehodd4 ý 2C[cehodd4 ý 2C[cehodd4...

21 Caller ID Operation ˆ Caller ID Operation If you subscribe to Caller ID service fromyour phone company, the phone companysends information about the call, as well asthe time and date, between the first and sec-ond rings of every call you receive. This in-formation appears after the second ring on...

22 Caller ID Operation is disconnected. JebZ JebZ JebZ JebZ 8kio 8kio 8kio 8kio appears on your phone. JWa[ JWa[ JWa[ JWa[ C[iiW][ C[iiW][ C[iiW][ C[iiW][ — Send a waiting caller to your phone company’s voice mail ser-vice. Je Je Je Je Le_Y[ Le_Y[ Le_Y[ Le_Y[ CW_b CW_b CW_b CW_b appears on your phon...

23 Caller ID Operation REVIEWING CALLER ID RECORDS (Handset Only) To review the Caller ID records in the hand-set's memory, lift the handset and press CID.The number of new Caller ID records, if any,and the total number of records appears. Note: If the handset is faceup on the base, itshows the numb...

25 Troubleshooting ˆ Troubleshooting We do not expect you to have any problems with your phone, but if you do, these suggestionsmight help. Problem Suggestion Low volume or unusual sounds. Someone has picked up another phone on the same line. Hang up the other phone. Severe noise interference. Press...

26 Troubleshooting If you still have problems, disconnect the phone. If other phones on the same line work proper-ly, the fault is in this phone or its installation. If you cannot find the problem, take your phone toyour local RadioShack store for assistance. CARE Keep the phone dry. If it gets wet,...