RadioShack 43-3533 - Manuals

Page 2 - guidelines for

2 +/2146#06 " 5#('6; " +05647%6+105 When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Read and understand all instructions. 2. Follow all warnings and instructi...

Page 4 - Always connect the AC adapter

4 In tr oduc tion 4. Exercise care in handling the battery pack in order not to short it with conducting materials such as rings, bracelets, and keys. The battery or conductor may overheat and cause burns. 5. Charge the battery pack provided or identified for use with this product only in accordance...

Page 5 - Battery; AC Adapter Cord

In s ta lla ti o n 5 To mount the phone directly on a wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the back of the base. Drill two holes 3 15 / 16 inches (100 mm) apart. Then thread a screw into each hole, letting the heads extend about 1 / 8 inch (3 mm) fro...

Page 6 - In

In s ta llati o n 6 4 '%*#4)+0) " 6*' " $ #66'4; " 2 #%- • If the CHARGE/IN USE indicator does not light when you place the handset on the base, be sure the battery pack and AC adapter are correctly and securely con-nected. Also, check the charging contacts on the hand-set and the base. ...

Page 7 - Setting the Dialing Mode

O perat ion 7 1. Lift the handset and listen for a dial tone. 2. Press any number other than 0 . ± If the dial tone stops, you have touch-tone service. If the dial tone continues, you have pulse service. To set the dialing mode, hold down FLASH until the phone beeps and TALK/BATT flashes, then press...

Page 9 - Storing a Number in Memory

O perat ion 9 3. Enter the number and any tone and pause entries (see “Using Tone Services on a Pulse Line” on Page 8 and “Entering a Pause” on Page 9). ± 4. Press MEM again, then enter the memory location number ( 0 – 9 ) where you want to store the number. A tone sounds to indicate that the number...

Page 10 - TQDNGO; Press CHANNEL to change the channel.; Hang up and redial the number.

T roubleshoot ing 10 6417$.'5*116+0) 2TQDNGO " 5WIIGUVKQPU Low volume or unusual sounds. Someone has picked up another phone on the same line. Hang up the other phone. If you are using the headset, make sure the headset’s plug is properly connected to the jack. Severe noise inter-ference. Keep t...

Page 11 - Care; Your phone complies with Part 68 of; coin-operated systems

Care 11 If you still have problems, disconnect the phone. If other phones on the same line work properly, the fault is in this phone or its installation. If you cannot find the problem, take the phone to your local RadioShack store for assistance. %#4' Keep the phone dry; if it gets wet, wipe it dry...

Page 12 - Printed in China; Limited One-Year Warranty

43-3533/3534/3541/3542/3543 UCZZ01367ZZ 06A02 Printed in China RadioShack CorporationFort Worth, Texas 76102 notice is not practical, the phone company notifies you as soon as possible and advises you of your right to file a complaint with the FCC. Also, the phone company can make changes to its lin...