QLogic QLE2362 - Manuals - manualsarea.com

Page 3 - Table of Contents

PX2454601-00 C Page iii Table of Contents Section 1 Introduction 1.1 How to Use this Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 1.2 General Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 1.3 What is Fibre...

Page 4 - Tables

QLE2360/2362 User’s Guide2-Gbps Fibre Channel to PCI Express Host Bus Adapters Page iv PX2454601-00 C Q Tables Table Page 2-1 HBA Operating Environment and Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-4

Page 5 - Section 1; Introduction; How to Use this Guide; unless otherwise noted.; General Description; Fibre Channel technology is outlined in the

PX2454601-00 C 1-1 Section 1 Introduction 1.1 How to Use this Guide The SANblade QLogic host bus adapters (HBAs) supported in this document are described in the following paragraphs; they are collectively referred to as the QLE2360/2362 HBA unless otherwise noted. ■ QLE2360 (single channel, half siz...

Page 6 - Technical Support; Visit the QLogic support Web site listed in; Availability

1 – IntroductionTechnical Support 1-2 PX2454601-00 C Q Fibre Channel supports data transfer rates up to 200 MBps half-duplex and 400 MBps full-duplex on optical interfaces. The QLE2360/2362 HBA uses a multimode optical interface for intermediate distances (less than 500 meters at the data rate of 1 ...

Page 9 - Part I; Hardware; This part of the

PX2454601-00 C I-1 Part I Hardware This part of the QLE2360/2362 User’s Guide describes the host bus adapters (HBAs) and how to install and configure them. Section 3 contains troubleshooting information. HBA Section QLE2360/2362 2

Page 10 - Notes

Page 11 - Section 2; . Take a minute to write down the serial number of the

PX2454601-00 C 2-1 Section 2 QLE2360/2362 2.1 QLE2360/2362 HBA Components Figure 2-1 identifies the QLE2360/2362 HBA components referenced throughout this section. The J2 transceiver and associated LED is only for the dual channel QLE2362. The QLE2360 is single channel; it uses only one of these tra...

Page 12 - LEDs; SANsurfer FC HBA Managers User’s Guide; Installation in the Computer

2 – QLE2360/2362Installation in the Computer 2-2 PX2454601-00 C Q 2.1.1 LEDs Figure 2-2 identifies and describes the activity of the QLE2360/2362 HBA LEDs. The red LED on the bracket is not used. For more information about the beacon LED activity, see the SANsurfer FC HBA Managers User’s Guide (FS00...

Page 13 - Remove the computer cover and save the screws.

2 – QLE2360/2362 Installation in the Computer PX2454601-00 C 2-3 Q Perform the following steps to install the QLE2360/2362 HBA in your PC: 1. Check the motherboard and make any configuration changes necessary to accommodate the QLE2360/2362 HBA. 2. Power down the peripherals, then the computer. 3. R...

Page 14 - see section 3; Installation Help; Table 2-1. HBA Operating Environment and Specifications; Host Bus Interface Specifications

2 – QLE2360/2362Specifications 2-4 PX2454601-00 C Q If the information displayed is not correct and you have checked the QLE2360/2362 HBA’s configuration, see section 3 for troubleshooting information. 2.2.1 Installation Help If your system has an IDE hard disk, it may be assigned device number 80, ...

Page 15 - Fibre Channel Specifications

2 – QLE2360/2362 Specifications PX2454601-00 C 2-5 Q Fibre Channel Specifications Data rate 2/1 Gbps auto-negotiation (2.1240/1.0625 Gbps) Compliance Second Generation FC Generic Services Definition (FC-GS-2), Third Generation FC Generic Services Definition (FC-GS-3), Fibre Channel-Physical and Sign...

Page 16 - xx; EMI and EMC Requirements; Software

2 – QLE2360/2362Label 2-6 PX2454601-00 C Q 2.4 Label The transceiver on the QLE2360/2362 HBA is a Class I laser product. It complies with IEC 825-1 and FDA 21 CFR 1040.10 and 1040.11. The transceiver must be operated under recommended operating conditions. 2.5 Agency Certification The following sect...

Page 18 - Product Safety Requirements; Class 1 Laser Product per DHHS 21CFR; 警告使用者

2 – QLE2360/2362Agency Certification 2-8 PX2454601-00 C Q ■ CNS 13438 Class A ❑ This is a class A product. In domestic environment this product may cause radio interference in which case the user may be required to take adequate measures 2.5.2 Product Safety Requirements ■ UL, cUL ❑ UL60950 ❑ CSA C2...

Page 20 - Laser Safety

2 – QLE2360/2362Agency Certification 2-10 PX2454601-00 C Q 2.5.3 Laser Safety ■ FDA Notice ❑ This product complies with DHHS Rules 21CFR Chapter I,Subchapter J. This product has been designed and manufactured according to IEC60825-1 on the safety label of laser product. ■ Class 1 Laser Product ❑ App...

Page 23 - Section 3; Troubleshooting; Problems After Installation; Are all of the circuit cards installed securely in the system?

PX2454601-00 C 3-1 Section 3 Troubleshooting 3.1 Problems After Installation There are three basic types of installation problems that can cause your QLE2360/2362 HBA to function incorrectly: hardware problems, system configuration problems, and Fibre Channel problems. The following section provides...