Pyle PLR7N - Manuals - manualsarea.com

Page 2 - authority to operate the equipment.

Any changes or modifications in construction of thisdevice which is not expressly approved by the partyresponsible for compliance could void the user ’ ’ s authority to operate the equipment.

Page 3 - WARNING

DO NOT DISASSEMBLE OR ALTER KEEP SMALL ARTICLES OUT OF THE REACH OF CHILDREN USE THE CORRECT AMPERE RATING WHEN REPLACING FUSES HALT USE IMMEDIATELY IF A PROBLEM APPEARS DO NOT OPERATE ANY FUNCTION THAT TAKES YOUR ATTENTION AWAY FROM SAFELY DRIVING YOUR VEHICLE Attempts to disassemble or alter may l...

Page 4 - CAUTION

CAUTION The exclamation point within an equilateral triangle and “ “ CAUTION ” ” are intended to alert the user to the presence of important operating instructions. Failure to heedthe instructions can result in injury or material damage. DO NOT RAISE THE VOLUME EXCESSIVELY Keep the volume at a level...

Page 6 - INTRODUCTION; MONITOR

INTRODUCTION MONITOR 4 ⑩ ① ② ⑨ ⑤ ③ ⑥ ⑧ ④ ⑦ ① ① POWER ON/OFF BUTTON ② ② MODE SELECTION BUTTON ③ ③ AS/ATM BUTTON ④ ④ SOUND MUTE BUTTON ⑤ ⑤ VOLUME UP/DOWN ADJUST BUTTON ⑥ ⑥ SEARCH UP/DOWN BUTTON ⑦ ⑦ OPEN/CLOSE BUTTON ⑧ ⑧ TILT UP/DOWN BUTTON ⑨ ⑨ BAND SELECTION BUTTON ⑩ ⑩ MENU SELECTION BUTTON

Page 7 - REMOTE CONTROLLER

① ① POWER ON/OFF BUTTON ② ② MODE SELECTION BUTTON ③ ③ AS/ATM BUTTON ④ ④ SOUND MUTE BUTTON ⑤ ⑤ VOLUME UP/DOWN BUTTON ⑥ ⑥ SEARCH UP/DOWN BUTTON ⑦ ⑦ OPEN/CLOSE BUTTON ⑧ ⑧ MANUAL MEMORY BUTTON ⑨ ⑨ CHANNEL UP/DOWN BUTTON ⑩ ⑩ NAVIGATION BUTTON ⑪ ⑪ ASPECT BUTTON ⑫ ⑫ MENU SELECTION BUTTON ① ② ③ ④ ⑤ ⑥ ⑦ ⑧ ⑨ ...

Page 8 - REMOTE CONTROL UNIT

REMOTE CONTROL UNIT Replacing battery Applicable battery : Use two “ AAA ” sized dry batteries. 1. Opening the battery cover. Push and slide the cover in the arrowdirection, and the cover will be removed. 2. Replacing the battery. Remove the old batteries. Insert new ones matching the (+) and (-)pol...

Page 9 - BASIC OPERATION; OPENING THE MONITOR; RADIO MAIN MENU

1. POWER ON 1) Press the POWER button to turn the power on. But the monitor will not open. 2) You can also turn the power on by pressing the OPEN/CLOSE button. The power will be on and the monitor will open. 2. POWER OFF 1) Press the POWER button again to turn the power off. 2) If you turn the power...

Page 10 - CLOSING THE MONITOR; ADJUSTING THE TILT POSITION

1. Hold left and right upper side of the monitor and set the left and right angle of the monitor parallel with the front of the unit as the picture. 2. Press OPEN/CLOSE button. The monitor will close. CLOSING THE MONITOR 1. If the left and right angle of the monitor is not parallel to the front of t...

Page 11 - ADJUSTING THE LEFT/RIGHT VIEWING POSITION; ADJUSTING THE SLIDE POSITION; NOTE

ADJUSTING THE LEFT/RIGHT VIEWING POSITION The monitor ’ s left/right position can be adjusted for easier viewing by hand-operating. 9 1. Press the MENU button repeatedly on radio or AV mode until the USER SELECTOR menu is selected. 2. Press the SEARCH UP/DOWN button to select MOVE3. Press the VOLUME...

Page 12 - SELECTING MODE

Press the MODE button to select the desired mode. Each time you press the button, themode changes as follows. RADIO -> AV1 -> AV2 -> AV3 (CD OR VCD CHANGER) -> AV4 (TV) 1. AV3 has only video input.2. The CD/VCD changer must be connected to the 8 pin DIN socket on the rear of the unit wit...

Page 14 - RADIO CONTROL; MANUAL TUNING

12 RADIO CONTROL Press the OPEN/CLOSE button to turn the power on and to open the monitor. The monitorshows following picture. MANUAL TUNING MANUAL STORING OF STATION Press the CH UP/DOWN button to move downward or upward one step respectively untilthe desired station frequency is selected. 1. Tune ...

Page 15 - RADIO SUB MENU

13 2. Press the SEARCH UP/DOWN button to select RADIO BAND.3. When RADIO BAND is selected, press CH UP/DOWN button to select the radio band area (EUROPE or USA) for your country. Each time you press the CH UP/DOWN button, the band switches as EUROPE --> USA SELECTING THE BAND AREA FOR YOUR COUNTR...

Page 17 - NAVIGATION

15 1. Connect a NAVIGATION system only to AV1 or AV2 Input terminals on the rear of the unit. 2. Press the MODE button to select radio mode.3. Press the MENU button to select following picture. NAVIGATION Do not select the AV mode connected to the NAVIGATION system withthe MODE button. If AV Input c...

Page 18 - CAMERA IN; SETTING THE CAMERA IN; WATCHING THE BACK VIEW PICTURE; WIRING CONNECTION

16 1. Connect a Back View Camera video output only to AV1,2 or 3 video Input terminals on the rear of the unit.* When the VCD changer is connected to AV3 Video input, The back view camera can be connected only to AV1 or AV2 video input. 2. Press the MODE button to select radio mode.3. Press the MENU...

Page 19 - CD CHANGER CONTROL; CD STATUS; DISK NUMBER

1. Each time the MENU button is pressed on CDC mode, the menu on the screen changes as follows.CD CHANGER -> VOLUME -> USER SELECTOR -> PICTURE -> OSD OFF 17 CD CHANGER CONTROL When a CD (VCD) changer is connected to this unit with 8 pin DIN cable, AV3 modechanges to CDC mode and CDC con...

Page 22 - VOLUME MENU

20 VOLUME ADJUSTMENT OF EACH CHANNEL 1. Press the MENU button repeatedly on radio or AV mode until VOLUME MENU is selected The monitor shows following picture. 2. Press the SEARCH UP/DOWN button to select the audio channel that you want to adjust. 3. Press the VOLUME ◀ or ▶ button to adjust the volu...

Page 24 - SCREEN CONTROL; USER SELECTOR MENU

22 2. Press the SEARCH UP/DOWN button to select the items that you want to adjust.3. Press the VOLUME ◀ or ▶ button to adjust the level of the selected item. SCREEN CONTROL 1. Press the MENU button when the monitor shows following picture. The monitor shows following picture. USER SELECTOR TILT POSI...

Page 25 - SELECTING COLOR/SOUND SYSTEM; PICTURE MENU

1. Press the SEARCH UP/DOWN button to select COLOR SYSTEM for the video source on PICTURE menu. SELECTING COLOR/SOUND SYSTEM 2. Press the VOLUME ◀ or ▶ button to select PAL or NTSC for the video source. To select the color system for the TV when the TV tuner box is connected to the AV4 inputof this ...

Page 26 - VOLUME CONTROL ON AV MODE

VOLUME CONTROL ON AV MODE 24 2. Press the SEARCH UP/DOWN button to select the items that you want to adjust. 3. Press the VOLUME ◀ or ▶ button to adjust the audio level of the selected item. To adjust audio level of AV sources on AV mode,1. Press the VOLUME ◀ or ▶ button. The monitor shows following...

Page 27 - WARNING SCREEN

25 The monitor shows following warning picture when the parking brake is not set or whendriving to prevent traffic accident that may be caused while watching the screen.The monitor shows the warning picture only and does not show any other pictures, but youcan enjoy the sound only by adjusting the v...

Page 28 - AV INPUT FACE PLATE OF THE UNIT

Front View Video Audio Yellow : Video White : Audio Left Red : Audio Right 26 AV INPUT FACE PLATE OF THE UNIT 3.5 Ø AV input on the front face of the unit is same input with AV1 input o n t h e r e a r o f t h e u n i t . I f t h e s o u r c e s a r e c o n n e c t e d b o t h i n p u tterminals,the...

Page 29 - INSTALLATION

27 Strap Be sure to use the strap to securet h e b a c k o f t h e u n i t i n p l a c e t oprevent sound cuts or skips.The strap can be bent by hand to thedesired angle. Holder A f t e r i n s e r t i n g t h e h o l d e r i n t o t h edashboard, select the appropriatetabs according to the thicknes...

Page 30 - BASIC CONNECTIONS

28 BASIC CONNECTIONS REMOTE TURN-ON AUTO ANT PARKING BRAKE ACC BATTERY (MEMORY) SPEAKERFRONTRIGHT SPEAKERREARRIGHT SPEAKERREARLEFT SPEAKERFRONTLEFT (Yellow) (Blue/White) (Red) (Brown) (Blue) (Gray) (Gray/Black) (Violet/Black) (Violet) (Green) (Green/Black) (White/Black) (White) To amplifier or equal...

Page 31 - CONNECTING TO CD CHANGER AND TV TUNER BOX

CONNECTING TO CD CHANGER AND TV TUNER BOX 29 Red White Red White Ye ll o w ANT . PRE AMP RCA LINE OUT Fr ont Right Fr ont Left Rear Right Rear Left Sub W oof er Right Left Video Red White Y ello w A V -1 INPUT 16P Connector CD (VCD) Chang er Ext. Monitor VIDEO in Video out (Y ello w) Video in (Y ell...

Page 32 - SPECIFICATIONS

30 SPECIFICATIONS AM SECTION USA BAND Frequency Range 530-1710KHz Frequency Step 10KHz EUROPE BAND Frequency Range 522-1620KHz Frequency Step 9KHz Intermediate Frequency 450 KHz Usable Sensitivity 32 dB Image Rejection Ratio 45dB IF Rejection Ratio 100dB FM SECTION Frequency Range 87.5~108 MHz Frequ...

Page 33 - Printed In Korea