Pyle PLCD69MP - Manuals - manualsarea.com

Page 2 - CONTENTS

2 Installation .....................................................................................................3 DIN Front-Mount (Method A) ..................................................................................3 Installing the unit ......................................................

Page 3 - Installing the unit; INSTALLATION

3 Notes: • Choose the mounting location where the unit will not interfere with the normal driving function of the driver. • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. • Use only the parts...

Page 4 - Removing the unit; Movable panel frame

4 INSTALLATION Removing the unit 1. Frame2. Release Frame Key Insert the release frame key into the groove at the right side of the frame, then prize out to remove the frame.(You can also use the key to remove the frame from the left side.) 3. Release Unit Key After releasing the frame, insert the r...

Page 5 - Then insert a disc in the disc slot, the; USING THE FRONT PANEL

5 3. Then insert a disc in the disc slot, the panel will automatically turn up to State 2. Press (eject) button again,the panel will turn down to eject the disc. If you don’t insert a disc in again, the panel will automatically turnup about 10 seconds. If you don’t want to wait, press (eject) button...

Page 6 - WIRING CONNECTION; MAIN UNIT

6 WIRING CONNECTION GREEN GREEN/BLACK GREY GREY/BLACK VIOLET VIOLET/BLACK MAIN UNIT WHITE WHITE/BLACK FRONT Lch SPEAKER REAR Lch SPEAKER FRONT RchSPEAKER REAR RchSPEAKER Rch RED Lch WHITE (GREY) RCA CABLE ANTENNA CONNECTOR RED BLUE POWER ANTENNA GROUND (B–) MEMORY BACK-UP IGNITION SWITCH (B+) SUBWOO...

Page 7 - GENERAL OPERATION; • SOUND ADJUSTMENT; SEL; OPERATION; • LOUDNESS; Press

7 GENERAL OPERATION • ON/OFF When the hiding panel turns up (in State 2), press button (9) to turn on the unit. When system is on, pressbutton (9) to turn off the unit. • SOUND ADJUSTMENT Press SEL button (10) to select the desired adjustment mode.The adjustment mode will change in OPERATION the fol...

Page 9 - RADIO OPERATION

9 • AUTOMATICALLY MEMORY STORING & PROGRAM SCANNING - Automatic Memory Storing Press AMS button (18) for several seconds, the radio searches from the current frequency and checks the signal strength level until one cycle search is finished.And then 6 strongest stations are stored into the corres...

Page 10 - CD OPERATION

10 CD OPERATION • CD OPEN/CLOSE/EJECT When the front panel is in State 2 andthe unit is on, press (eject) button (4),the panel will change into State 3 anddisplay the disc slot (5). Then insert adisc into the slot, the panel will automatically turn up. Press (eject) button (4) again to eject the dis...

Page 11 - REMOTE CONTROL HANDSET; PWR

OPERATION REMOTE CONTROL HANDSET FUNCTION KEYS & CONTROL 1. PWR = Power ON/OFF Button 2. DSP (0) = Display Button (_, -, +, 0) 3. SEL = Select Button (Character Shift Right) 4. VOL = Volume Up Button [Charater Select (A, B~8,9,0)] 5. VOL = Volume Down Button [Charater Select (A, B~8,9,0)] 6. BND...

Page 14 - FM; SPECIFICATION

GENERAL P ower Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 178 (W) x 165 (D) x 50 (H) Tone Controls- Bass (at 100 Hz) : ± 10 dB - Treble (at 10 KHz) : ± 10 dB Maximum Output P ower : 4 x 60 Watts Current Drain : 15 Ampere (max.) CD PLA YER Signal to Noise Ratio : More tha...

Page 15 - TROUBLE SHOOTING; Symptom; The car ignition switch is

TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problemspersist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power. The car ignition switch is If the power supply is properly not on. connected to the car a...