Pyle PLCD67 - Manuals - manualsarea.com

Page 2 - CONTENTS

2 Installation .....................................................................................................3 DIN Front-Mount (Method A) ..................................................................................3 Installing the unit ......................................................

Page 3 - Installing the unit; INSTALLATION

3 Notes: • Choose the mounting location where the unit will not interfere with the normal driving function of the driver. • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. • Use only the parts...

Page 4 - Removing the unit; Select a position where the screw

4 INSTALLATION Removing the unit 1. Before removing the frame, press the OPEN/CLOSE button to slide down the front panel. 2. Frame3. Insert fingers into the groove in the right side of the frame and pull out toremove the frame. (You can also remove the frame from the left side.) 4. Lever After remov...

Page 5 - To Reinstall the Front Panel; USING THE DETACHABLE FRONT PANEL; To Detach the Front Panel

5 To Reinstall the Front Panel 1. When the panel bracket is in slide down position, insert the front panel into panel bracket and press OPEN/CLOSE button to slide up. 2. When the panel bracket is in slide up position, insert a side of the front panel to its proper position and pushthe other side int...

Page 6 - WIRING CONNECTION

6 WIRING CONNECTION GREEN GREEN/BLACK GREY GREY/BLACK VIOLET VIOLET/BLACK MAIN UNIT WHITE WHITE/BLACK FRONT Lch SPEAKER REAR Lch SPEAKER FRONT RchSPEAKER REAR RchSPEAKER Rch RED Lch WHITE (GREY) RCA CABLE ANTENNA CONNECTOR RED YELLOW BLACK BLUE POWER ANTENNA GROUND (B–) MEMORY BACK-UP IGNITION SWITC...

Page 7 - GENERAL OPERATION; button; EJECT; When system is on, press; POWER; OPERATION; • SOUND ADJUSTMENT; Press; SEL

7 GENERAL OPERATION • ON/OFF Switch on the unit by pressing any button (except OPEN/CLOSE button (7) and EJECT button (4)). When system is on, press POWER button (9) to turn off the unit. • FACEPLATE RELEASE Press OPEN/CLOSE button (7) to slide down the front panel and you can OPERATION press it aga...

Page 8 - RADIO OPERATION

For Electrical Volume:By pressing AUDIO CONTROL button (11) or AUDIO CONTROL button (12), it is possible to adjust thedesired sound quality.For Digital Rotating Volume:By rotating the knob (11 & 12) clockwise or counter-clockwise, it is possible to adjust the desired sound quality. • LOUDNESS Pr...

Page 9 - CD OPERATION

9 retune to seek tuning mode and “AUTO” appeared on the display. • LOCAL/DISTANCE Press LOC button (3) shortly to select between local and distant stations. Local setting for reception of strong station, and a distant setting for reception of weaker stations. • AUTOMATICALLY MEMORY STORING & PRO...

Page 11 - SPECIFICATION; GENERAL; FM

11 SPECIFICATION GENERAL P ower Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 178 (W) x 180 (D) x 50 (H) Tone Controls- Bass (at 100 Hz) : ± 10 dB - Treble (at 10 KHz) : ± 10 dB Maximum Output P ower : 4 x 50 Watts Current Drain : 5 Ampere (max.) CD PLA YER Signal to Noise ...

Page 12 - TROUBLE SHOOTING; Symptom

TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problemspersist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power. The car ignition switch is If the power supply is properly not on. connected to the car a...