Pyle PLCD65WXMU - Manuals - manualsarea.com

Page 2 - CONTENTS

2 CONTENTS Installation ...........................................3 Take out screw before installation.........3DIN Front-Mount (Method A) ................3 Installing the unit.................................3Removing the unit ...............................4 DIN Rear-Mount (Method B) ...............

Page 3 - INSTALLATION; Installation Opening

3 INSTALLATION Notes: • Choose the mounting location where the unit will not interfere with the normal driving function of the driver. • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. • Use o...

Page 4 - Removing the unit

grounding of the unit.Note to install the short threadingterminal of the mounting bolt to the backof the unit and the other long threadingterminal to the dashboard. 10. Reconnect the cable to the vehicle battery's negative (-) terminal. Then replace the outer trim ring and install the unit's front p...

Page 5 - the outer trim ring, sleeve and the

DIN REAR-MOUNT (Method B) If your vehicle is a Nissan, Toyota, followthese mounting instructions.Use the screw holes marked T (Toyota),N (Nissan) located on both sides of theunit to fasten the unit to the factory radiomounting brackets supplied with yourvehicle. To fasten the unit to the factory rad...

Page 6 - USING THE DETACHABLE FRONT PANEL; REMOVING THE FRONT PANEL; Precautions when handing

USING THE DETACHABLE FRONT PANEL REMOVING THE FRONT PANEL 1. Press the release button ( ) on the front panel and pull off the front panel. 2. Keep front panel into the case. INSTALLING THE FRONT PANEL To install the front panel, insert the panelinto the housing and make sure the panelis properly ins...

Page 7 - WIRING CONNECTION

7 WIRING CONNECTION FRONT LchSPEAKER GREEN GREEN/BLACK MEMORYBACK-UP (B+) MAIN UNIT Rch RED Lch WHITE AUX IN CABLE IGNITIONSWITCH (ACC+) POWERANTENNA RED GROUND (B–) YELLOW BLACK BLUE RCA CABLE (BLACK) ANTENNA CONNECTOR (GREY) Rch RED Lch WHITE WHITE WHITE/BLACK REAR LchSPEAKER VIOLET VIOLET/BLACK G...

Page 8 - OPERATION; LOCATION OF KEYS

8 OPERATION LOCATION OF KEYS 12 17 7 18 15 10 5 8 11 9 4 24 21 20 22 2 3 1 6 19 13 16 14 23

Page 9 - RADIO OPERATION

9 OPERATION SWITCHING ON/OFF THE UNIT Switch on the unit by pressing any button(except button (7) and button (4)).When system is on, press POWER button (9) to turn off the unit. FACEPLATE RELEASE Press button (7) to detach the removablefaceplate. SOUND ADJUSTMENT Press PUSH SEL button (10) shortly t...

Page 12 - MOD; • Searching From Root Directory

KEY Assigned IN Searching mode(Table 1) AUDIO KONB (ENCODER) &TUNE/TRACK UP/DOWN buttons:Searching file and directory during Navigation. WMA OPERATION The unit that can play the WMA disc and the operation is the same with MP3 operation described above. USB PLAY OPERATION In the front panel of th...

Page 13 - RECORD OPERATION; DISC NOTE

OPERATION in the device, the operation is the same with the MP3 operation described above. Note: • The main unit can only support the standard USB-memory disc which is approved by Microsoft. • USB MP3 player is not a standard which means different brand name or different models have their own standa...

Page 14 - REMOTE CONTROL HANDSET; FUNCTION KEYS & CONTROL; PWR

14 REMOTE CONTROL HANDSET FUNCTION KEYS & CONTROL 1. PWR = Power ON/OFF Button 2. DSP (0) = Display Button (_, –, +, 0 For MP3/WMA Operation ) 3. SEL = Sound Mode Select Button (Character Shift Right ForMP3/WMA Operation ) 4. VOL = Volume Up Button [Character Select (A, B ~ 8, 9, 0) ForMP3/WMA O...

Page 15 - SPECIFICATION; GENERAL; FM

15 SPECIFICATION GENERAL P ower Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 178 (W) x 160 (D) x 50 (H) Tone Controls- Bass (at 100 Hz) : ± 10 dB - Treble (at 10 KHz) : ± 10 dB Maximum Output P ower : 4 x 50 Watts Current Drain : 15 Ampere (max.) CD PLA YER Signal to Noise...

Page 16 - TROUBLE SHOOTING; Symptom

88-C2007-02 TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problemspersist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power. The car ignition switch is If the power supply is not on. connected to the ca...